124970930?EW1478F?gb 21-06-2000 17:04 Pagina 7
Installation
5. Pull out the three plastic spacers from the holes
Unpacking
into which the bolts were fitted.
All transit bolts and packing must be removed6. Plug the open holes with the plugs which you will
ENGLISH
before using the appliance.find at the back of the appliance.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the rear
right-hand bolt and lay the machine on its back,
taking care not to squash the hoses. This can be
avoided by placing one of the corner packing
pieces between the machine and the floor.
P0020
Positioning
Install the machine on a flat hard floor.
Make sure that air circulation around the machine is
not impeded by carpets, rugs etc. Check that the
machine does not touch the wall or other kitchen
units.
P0255Carefully level by screwing the adjustable feet in or
out. Never place cardboard, wood or similar
2. Remove the polystyrene block from the undersidematerials under the machine to compensate for any
of the machine and release the two plastic bags.
unevenness in the floor.
3. Carefully remove the right-hand bag (1) then the
left-hand bag (2) by pulling them towards the
centre of the machine.
2
1
P1051
Water inlet
P1068P1066
Connect the water inlet hose to a tap with a 3/4"
4. Set the machine upright and remove the two
thread.
remaining bolts from the back.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
P0256
P1088
P0021
7 |
ACEC
ELECTROLUX
