11. How to change an option or aAfter approximately 3 minutes, you can open the
door.
programme during its cyclePay attention to the level and temperature of the
Before you make any change, you must pause thewater in the machine!
When you close the door and press the ON/OFF
machine by pressing the START/PAUSE button.
button again, the machine will resume the
It is possible to change the temperature or anyprogramme from the point where it had been
option before the programme carries it out.interrupted.
Changing a running programme is possible only by
cancelling it and selecting a new programme.
14. At the end of the programme
The machine will resume the cycle from the
beginning and the washing water in the tub will not
At the end of the programme, the machine stops
emptied out.automatically, gives an audible signal, and displays a
If it is necessary to drain the water in order to changeblinking zero.
the programme in progress, proceed as follows:If you had selected the RINSE HOLD option, the
? PAUSE the machine by pressing theSTART/PAUSE button light goes out to indicate that
START/PAUSE button;the water must be drained. At the same time the
? press the SKIP/RESET button repeatedly, until onlydisplay shows a blinking zero and the DOOR
the light remains lit;LOCKED light is on.
? press the START/PAUSE button again.When the programme has been completed, a
blinking zero appears on the display and the audible
When the water has been drained, the display showssignal is given.
a blinking zero.
The DOOR LOCKED light goes out at once.
You may now select a new programme and press
the START/PAUSE button to start it.Press the SKIP/RESET button repeatedly to erase
the programme that has just been carried out. If
you omit to do this, the next time you switch the
12. How to cancel a programmemachine on, the blinking zero will appear on the
during its cycledisplay and you will hear the audible signal.
Note: when you switch the machine on, if you must
To cancel a programme that is being carried out, firsterase the previously performed programme, it is also
pause the machine by pressing the START/PAUSEsufficient to press the FABRICS button and select a
button , then press the SKIP/RESET buttonnew programme.
repeatedly, until the display shows three blinkingPress the ON/OFF button to switch the machine off.
dashes.
The relevant light will go out.
Remove the laundry from the machine.
13. How to open a programmeCheck whether the drum is completely empty, by
during its cyclerotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
You can open the door, after having set the machineaccidentally in the drum, where they might get
to PAUSE, provided the following conditions exist:damaged in
? the machine is not in the heating phase;a subsequent wash (e.g. by shrinking) or bleed
? the level of the water is not high;
colour into another load of laundry.
? the drum is not turning.
If these requirements are met, when you pause theWe advise you to close the water supply tap and
machine, the DOOR LOCKED light goes out and thedisconnect the plug from the socket.
door can be opened.Leave the door ajar in order to air the machine.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off by pressing the ON/OFF button.
20 |
ACEC
