EXA1[DOM].book Page 38 Monday, December 22, 2003 3:33 PM
Listening to the sound of Auto Standby
other audio device
If there is no operation for 3 minutes while the disc
is stopped, the power will be automatically turned
off.
Connect the other audio device to this system in 1Press A.STANDBY during playback
advance (A page 10).or while the disc is stopped, or no
disc is loaded (?NO DISC? is
1Press AUX.
displayed).
The source changes to AUX.
?A.S.ON? (Auto Standby On) and ?A.STANDBY?
2Play the other audio device.will be lit on the display window on the main unit.
For details, refer to the manual of the device
When a stopped state is entered (after playback is
connected.finished, for example), ?A.STANDBY? starts
blinking.
3Adjust the volume and the This means that the power will be turned off
sound quality of the system automatically if there is no operation for 3 minutes.
(A page 16).And, 20 seconds before the power is turned off,
?POWER OFF? will appear blinking.
Adjust the sound input Releasing Auto Standby
Press A.STANDBY.level of the audio device
?A.S.OFF? (Auto Standby Off) will appear and
You can adjust the sound input level of another ?A.STANDBY? will be turned off on the display
audio device connected to the AUX jack.window on the main unit.
1Press AUX.NOTE
The source changes to AUX.When the source is FM/AM or AUX, Auto Standby
does not work.
2Hold down MEMORY until an
input level is displayed.
Each time you hold down the button, it switches
as follows:
LEVEL 1: Select this normally.
LEVEL 2: Select this when the input level
from the other device is too high
and the sound is distorted.
The initial setting is ?LEVEL1?.
38 |
ACEC
JVC
