4. Parameters
This document explains the parameters that appear the
screen pages that are added when the EXB-MOSS is
installed. For details on the other screen pages, refer to
the Parameter Guide and Basic Guide etc. of the
TRITON.
In Program mode, you can use the Write Program
page menu command to write an edited program into
the specified program number.
When you press the front panel [REC/WRITE]
key, the OUpdate Program� dialog box will
appear. Here too, you can write to the cur-
rently selected program.
Be sure to write important programs that youDepending on the oscillator types or effect
edit. If you turn off the power or select anothertypes used by the programs, a certain interval
program before you write, your edits cannot beof time may be required after a program is
recovered. Refer to OSaving data� on p.37 ofselected until it actually changes.
the TRITON Basic Guide.
0�2: Arpeggio
Here you can perform simple editing of the
arpeggiator.
Program mode
For details on the parameters, refer to p.3 O0�2:
Arpeggio� of the TRITONOs Parameter Guide.
Program P0: Play
0�1: Perf.Edit (Performance Edit)
Here you can select a program and perform simple
editing.
For details on the parameters, refer to p.1 O1. Program
mode� of the TRITON Parameter Guide.
Parameters that can be controlled from the Performance
Editor
OctaveOctave of OSC1, OSC2, and Sub OSC
PitchCannot be used for bank F.
OSC Balance OSC 1 and 2 levels of OSC Mixer 1
and 2
Amp LevelOutput level
Attack Time Amp EG, EG1,2,3,4
Attack Time, Time Modulation At
(controls the EG selected by Filter 1, 2,
Filter EG, Amp 1, 2, and Amp Level
EG)
Decay Time Amp EG, EG 1, 2, 3, 4
Decay Time, Slope Filter (controls the
EG selected by Filter 1, 2, FilterEG,
Amp1, 2, and Amp Level EG)
IFX Balance Wet/dry balance of each effect IFX1�5
MFX Balance Master effect return 1, 2
11 |