40105150aGB.fm Page 29 Wednesday, November 17, 2004 4:59 PM
b.Draining failureflash. If a digital display is fitted, ?A? and ?F? are also
Waste water not pumped out. displayed alternately.
For models with a failure display, the spin speed If the washing machine has an LCD, this notice appears:
indication LEDs flash. If a digital display is fitted, ?P? and ?
?F? are also displayed alternately.Water Stop Failure?
For models with LCD Display, the following notice For models with no failure display, the washing machine
appears:stops in the appropriate programme step.
Switch the appliance off, pull out the mains plug and
turn the water tap off.
For models with no failure display, the washing machine
Tilt the appliance forwards carefully to allow the
stops in the appropriate programme step.collected water to flow out from the bottom of the
Switch the appliance off and pull out the mains plug.appliance.
Check whether:Then:
The drain hose is kinked1. Connect the appliance to the electrical supply.
The pump or the foreign body trap is blocked (see 2. Turn the water tap on (if water immediately flows
?Removing The Filter?)into the appliance again, without the appliance being
IMPORTANT: Before draining, make sure that the started, there is a failure. Turn off the tap and notify
water has cooled down.After Sales Service).
The water in the drain hose is frozen up3. For models with failure display, select and start the
Reconnect the appliance to the electrical socket.desired programme again.
For models with failure display, select and start the If the failure occurs again, please contact After Sales
?Drain/Cancel? programme.Service (see ?After-Sales Service?).
For models without a failure display continue the ?Water Stop? failure when the programme
programme by pressing the ?On/Off? button again.selector switch marking is on top (?Off? position).
If the failure occurs again, please contact After Sales The pump is switched on automatically in order to
Service (see ?After-Sales Service?).pump the water out.
c. Failure in an electrical componentFor models with failure display the washing machine
The appliance stops in the middle of a programme.will also detect a Water Stop failure (leak) if the
programme selector is in the ?Off? position.
If a digital display or LCD is fitted, ?F4? to ?F31? will In this case the digital display (if fitted) alternately shows
also be displayed.
?A? and ?F?.
First of all select and start the ?Drain? or ?Drain/The LCD (if fitted) shows this notice:
Cancel? programme.
Then select and start the desired programme again. ?
Water Stop failure?
For models with no failure display, the washing machine
stops in the appropriate programme step.For models with no failure display, the ?Water Stop?
failure is detected when the appliance is switched on
Switch the washing machine off and on again to again.
continue with the programme.
Pull the mains plug out and ensure that the water tap is
If the failure occurs again, please contact After Sales turned off.
Service (see ?After-Sales Service?).Tilt the appliance forwards carefully to allow the
d.?Water Stop? failure (if fitted)
collected water to flow out.
The ?Water Stop? failure may have been triggered by:Then:
1. excess foaming.1. Connect the appliance to the electrical supply.
2. A leak in the washing machine.2. Turn the water tap on (if water immediately flows
In this case the pump is switched on automatically in into the appliance again, without the appliance being
order to pump the water out.started, there is a failure. Turn off the tap and notify
For models with a failure display, the ?Water Stop? After Sales Service).
indication flashes and the spin speed indicator LEDs
29
Black process 45.0° 100.0 LPI |
ACEC
BAUKNECHT
