10) Do not use the tool continuously for a long Other types of batteries may burst
period of time. Stop using the tool from time causing personal injury and damage.
to time to avoid temperature rise and heat 4) Do not expose charger and battery pack
overload of the motor.to rain or snow.
11) Do not drop the tool.5) To reduce risk of damaging the electric
plug and cord, pull by plug rather than
Symbol Meaningcord when disconnecting charger.
6) Make sure cord is located so that it
VVolts
will not be stepped on, tripped over, or
otherwise subjected to damage or stress.
Direct current
7) An extension cord should not be used
unless absolutely necessary.
n0No load speedUse of improper extension cord could
result in a risk of fire and electric shock.
Revolutions or reciprocations If extension cord must be used, make
/min
per minutessure that:
a. pins on plug of extension cord are
AhElectrical capacity of battery packthe same number, size and shape as
those of plug on charger.
b. extension cord is properly wired and
in good electrical condition.
WARNING! c. wire size is large enough for ampere
Some dust created by power sanding, sawing, rating of charger as specified below.
grinding, drilling, and other construction
RECOMMENDED MINIMUM AWG SIZE OF
activities contains chemicals known to the
EXTENSION CORDS FOR
State of California to cause cancer, birth
BATTERY CHARGERS
defects or other reproductive harm. Some
AC Input Rating. AmperesAWG Size of Cord
examples of these chemicals are:
Equal to or But less Length of Cord,
? Lead from lead-based paints
greater thanthanFeet
? Crystalline silica from bricks and
5 50 100 150
cement and other masonry products
018 18 18 16
? Arsenic and chromium from chemically-
treated lumber.
8) Do not operate charger with damaged
To reduce your exposure to these
cord or plug-replace them immediately.
chemicals: work in a well ventilated area,
and work with approved safety equipment, 9) Do not operate charger if it has received
such as dust masks that are specially a sharp blow, been dropped, or other-
designed to filter out microscopic particles.wise damaged in any way; take it to a
qualified service personnel.
10) Do not disassemble charger; take it
to a qualified service personnel when
III. FOR BATTERY CHARGER
service or repair is required. Incorrect
reassembly may result in a risk of
& BATTERY PACK
electric shock or fire.
Important Safety Instructions11) To reduce the risk of electric shock,
unplug charger from outlet before
1) SAVE THESE INSTRUCTIONS -This
attempting any maintenance or cleaning.
manual contains important safety and
1) The charger and battery pack are
operating instructions for battery charger
EY0L80.specifically designed to work together. Do
not attempt to charge any other cordless
) Before using battery charger, read all
tool or battery pack with this charger.
instructions and cautionary markings
on battery charger, battery pack, and 13) Do not attempt to charge the battery
product using battery pack.pack with any other charger.
3) CAUTION -To reduce the risk of injury, 14) Do not attempt to disassemble the
charge only Panasonic Battery Pack as battery pack housing.
shown in last page.15) Do not store the tool and battery pack
- 5 -
EY7540(UL).indb 52006/09/07 16:58:29 |
ACEC
PANASONIC
