Installation
Unpacking6. Set the machine upright and remove the
remaining rear screw. Slide out the relevant pin.
All transit bolts and packing must be 7. Plug all the holes with the plugs which you willENGLISH
removed before using the appliance.find in the envelope containing the instruction
booklet.
You are advised to keep all transit devices so that
they can be refitted if the machine ever has to be
transported again.
1. Using a spanner, unscrew and remove the two
rear bottom screws. Slide out the two plastic pins.
Positioning and levelling
Install the machine on a flat hard floor.
2. Lay the machine on its back, taking care not toMake sure that air circulation around the machine is
squash the hoses. This can be avoided bynot impeded by carpets, rugs etc. Check that the
placing one of the corner packing pieces betweenmachine does not touch the wall or other kitchen
units.
the machine and the floor.Carefully level by screwing the adjustable feet in or
3. Remove the polystyrene block(s) from the bottomout. Never place cardboard, wood or similar
of the machine. Unscrew and remove the fourmaterials under the machine to compensate for any
feet. Release the two plastic bags.unevenness in the floor.
4. Very carefully slide out the left polythene bag,
removing it towards the right and then downwards.
Water inlet
5. Very carefully slide out the right polythene bag,Connect the water inlet hose to a tap with a 3/4"
removing it towards the left and then upwards. thread.
The other end of the inlet hose which connects to the
machine can be turned in any direction. Simply
loosen the fitting, rotate the hose and retighten the
fitting, making sure there are no water leaks.
7 |
ACEC
ZANUSSI
