Water inletWater drainage
Connect the machine to a cold water tap with a 3/4"The end of the drain hose can be positioned in three
thread by means of the water inlet hose situated atways:
the back of the appliance. Do not use to this purpose
Hooked over the edge of a sink using the plastic
old hoses already employedhose guide supplied with the machine. In this
The other end of the inlet hose which connects to thecase, make sure the end cannot come unhooked
machine can be turned in any direction. Simplywhen the machine is emptying.
loosen the fitting, rotate the hose and retighten theThis could be done by tying it to the tap with a piece
fitting, making sure there are no water leaks.of string or attaching it to the wall.
The inlet hose must not be lengthened. If it is too
In a sink drain pipe branch. This branch must be
short and you do not wish to move the tap, you will
above the trap so that the bend is at least 60 cm
have to purchase a new, longer hose specially
above the ground.
designed for this type of use.
Directly into a drain pipe at a height of not less
Important!
than 60 cm and not more than 90 cm.
Before connecting up the machine to new pipeworkThe end of the drain hose must always be
or to pipework that has not been used for some time,ventilated, i.e. the inside diameter of the drain pipe
run off a reasonable amount of water to flush out anymust be larger than the outside diameter of the drain
debris that may have collected in the pipes.hose.
The drain hose must not be kinked.
For a correct functioning of the machine the
drain hose must remain hooked on the proper
support piece situated on the top part of the back
side of the appliance.
8 |
ACEC
ZANUSSI
