1,5 m. Max.
60 cm. Min.90 cm. Max.
IMPORTANT: The distance from the floor to the
Electrical connections
highest part of the hose should be between 60 toBefore plugging the appliance make sure that:
90 cm. (It is advised to be between 60 and 70 cm).
The hose must not be bent nor twisted to avoid11. the mains of your installation is the same as on
clogging. Should a prolongation of the dischargingthe rating plate of your appliance (the plate is
hose be unavoidable this must never surpass 1.5 msticked to the rear of the appliance).
and must be of the same diameter as the original21. The meter, the fuses, the wiring and the socket
hose.outlet can support the max. power absorbed stated
Make sure the hoses are not too tense.on the rating plate.
31. The socket base and the plug must fit in
Levellingadequately without any reducing interposition,
multiple outlets or adapters. If necessary replace
Level the appliance by loosening or tightening thethe socket outlet by an adequate one.
feet. Once in the right position fix the feet by
pushing the nuts (A) (see graphic P0254) againstThe applicable rules for electrical security
the base of the case. Accurate levelling will preventrequire an adequate earthing. The plug of the
vibration, noise and displacement of the applianceappliance is provided with such a device.
during operation.
Make sure your socket outlet is provided with
Some vibration is inevitable, especially if placed onan adequate earthing too.
a wooden floor. Wooden floors are particularly
susceptible to vibrations. If possible always placeThe manufacturer declines any liability in case
the appliance on a solid floor.of accidents or incidents should these safety
measures not be observed.
The power supply cable only can be replaced by
a person of our Service Force Centre.
P0254
32 |
ACEC
ZANUSSI
