strip disappear into the nozzle housing.(fig.11)Replacing the dustbag
4 With the nozzle positioned lengthwise and
1 Replace the dustbag as soon as the dustbag-
the brush strip folded in, you can vacuumfull indicator changes colour (even when the
clean small soft floor areas.Turn the tube 90nozzle is not placed on the floor).(fig.20)
degrees anti-clockwise again until it is
positioned lengthwise with the brush strip2 Switch the appliance off.
still folded in.(fig.12)
3 Open the cover by pulling it upwards.(fig.21)
Place you fingers at the inlet of the cover and
Crevice tool and small nozzlepress with your thumb on the ridge on top of the
1 Connect the crevice tool (1) or small nozzlecover.
(2) directly to the handgrip or to the
4 Lift the dustbag holder out of the
Accessory holderMake sure you hold the dustbag upright when
lifting it out of the appliance.
1 The accessory holder can simply be snapped
onto the handgrip.(fig.14)5 Remove the full dustbag from the holder by
pulling the cardboard tag.(fig.23)
Ã— The crevice tool and the small nozzle can be
stored in the accessory holder by pushingWhen you do this, the dustbag will be
them in the holder.(fig.15)automatically sealed.
Please note the way in which the small nozzle
must be placed in the accessory holder.6 Slide the cardboard tag of the new dustbag
into the two grooves of the dustbag holder as
far as possible. Re-insert the dustbag holder
Vacuum cleaninginto the vacuum cleaner.(fig.24)
Adjusting suction power
You cannot close the cover if no dustbag has
Ã— You can adjust the suction power whilebeen inserted.
Ã— If provided, you can use the cotton dustbag
1 Adjust the suction power by means of theinstead of paper dustbags.The cotton dustbag
electronic suction power control.(fig.16)can be used and emptied repeatedly.
2 Set the knob to MAX for maximum suctionTo empty the cotton dustbag:
- Hold the dustbag over a dustbin.
Use maximum suction power for vacuum- Remove the clip by sliding it off the dustbag
cleaning very dirty carpets and hard floors.sideways.
- Undo the metal hooks.
3 Set the knob to MIN for minimal suction- Close the dustbag by fastening the metal hooks
power.and sliding the clip back onto the bottom edge
Use minimum power for vacuum cleaningof the dustbag.
curtains, table carpets, etc.
Parking the tube
Philips s-baga paper dustbags are available under
Ã— By inserting the ridge on the nozzle in thetype number FC8021 (4822480101113).
parking slot, you can park the tube in aPhilips s-baga clinic high filtration dustbags are
available under type number FC8022
Storing the vacuum cleaner(883802201010).
1 You can put the appliance in upright positionPhilips cotton dustbags are available under
and attach the nozzle to the appliance bynumber FC8020 (432200493291).
inserting the ridge on the nozzle in the