1329898690GB.qxd 04/05/2004 16:10 Pagina 83 (Nero/Process Black pellicola)
When the water has been drained, the display showsPress the SPECIALS/ANNULL. button repeatedly
a blinking zero. You may now select a newto erase the programme that has just been
programme and press the START/PAUSE button tocarried out. If you omit to do this, the next time
start it.you switch the washing machine on, the blinking
zero will appear on the display and you will hear
the audible signal.
12. How to cancel a programmeNote: when you switch the machine on, if you must
during its cycle
erase the previously performed programme, it is also
To cancel a programme that is being carriedsufficient to press the FABRICS button and select a
out, first pause the washing machine bynew programme.
pressing the START/PAUSE button, then pressPress the ON/OFF button to switch the machine off.
the SPECIALS/ANNULL. button repeatedly, untilThe relevant light will go out.
the display shows three blinking dashes.Remove the laundry from the washing machine.
Check whether the drum is completely empty, by
13. How to open the door during therotating it with your hand. The purpose of this is to
prevent any items of laundry from remaining
cycle of a programmeaccidentally in the drum, where they might get
You can open the door, after having set the washingdamaged in a subsequent wash (e.g. by shrinking) or
machine to PAUSE, provided the followingbleed colour into another load of laundry.
conditions exist:We advise you to close the water supply tap and
the washing machine is not in the heating phase;disconnect the plug from the socket.
the level of the water is not high;Leave the door ajar in order to air the washing
machine.
the drum is not turning.
If these requirements are met, when you pause the
washing machine, the DOOR LOCKED light goes out
and the door can be opened.
Should it not be possible to open the door, and
should it be absolutely necessary to do so, switch
the machine off by pressing the ON/OFF button.
After approximately 3 minutes, you can open the
door.
Pay attention to the level and temperature of the
water in the washing machine!
When you close the door and press the ON/OFF
button again, the washing machine will resume the
programme from the point where it had been
interrupted.
14. End of programme
At the end of the programme, the washing machine
stops automatically, gives an audible signal, and
displays a blinking zero.
If you had selected the option, the START/PAUSE
button light goes out, the light of the option and
the DOOR LOCKED light remain lit to indicate that the
water must be drained. The display shows a blinking
zero.
When the programme has been completed, a
blinking zero appears on the display and the audible
signal is given.
The DOOR LOCKED light goes out at once.
83 |
ACEC
ZANUSSI
