FO-1460AT/BE/CH
FO-1460CS/HU/PL
3. Diagnostic items description3. 6. Signal send mode
The mode is used to send various signals to the circuit during FAX com-
3. 1. Soft switch modemunication. Every push of START key sends a signal in the following
sequence. Moreover, the signal sound is also output to the speaker when
Used to change the soft switch settings.
the line monitor of the soft switch is on.
The soft switch which is stored internally is set by using the keys.[1] No signal (CML signal turned on)
The available soft switches are SW-A1 to SW-M2.[2] 9600bps
The content of soft switches is shown in page 2-5 to 2-16.[3] 7200bps
The contents are set to factory default settings.[4] 4800bps
[5] 2400bps
3. 2. ROM & RAM check
[6] 300bps (FLAG)
ROM executes the sum check, and RAM executes the matching test.
[7] 2100Hz (CED)
The result will be notified with the number of short sounds of the buzzer
as well as by printing the ROM & RAM check list.[8] 1100Hz (CNG)
Number of short sounds of buzzer 0 ? No error[9] END
1 ? ROM errorThe signal can be checked by plugging the handset into the TEL line
connector on the rear of the machine.
2 ? RAM error (32Kbyte)
3. 7. Memory clear
3. 3. Aging mode
This mode is used to clear the backup memory and reset to the default
If any document is first present, copying will be executed sheet by sheet.settings.
If no document is present, the check pattern will be printed sheet by
sheet. This operation will be executed at a rate of one sheet per 5min-3. 8. CCD adjust mode
utes, and will be ended at a total of 10 sheets.
This mode is used to adjust the optical system. Since the copy is func-
tion performed, set the original. To abort the copy operation, press the
3. 4. Panel key test
STOP key. To restart press the START key. When the copy is completed
The mode is used to check whether each key properly operates or or when the STnot.OP key is pressed in the interruption state, exit from this
Since the key is displayed on LCD when the key on the operation panelmode occurs.
is pressed, press all the keys. Here, finally press STOP key.
When STOP key is pressed, the keys not judged as "pressed" are out-
3. 9. All black print
put in the result list. (The result list is not output in the process-diagnosis
mode.) Here, the LED port can be turned on for CCD adjustment duringThe mode is used to check the state of the printing head and inten-
the time from the start of the panel check mode to the end with the stoptionally overheat it. Whole dots are printed over the interval of 2 m. If it is
key.overheated or the printing sheet is jammed, press STOP key for the end.
3. 5. Check pattern3. 10. Auto feeder mode
The mode is used to check the state of the printing head. It is ended The mode is used to check the auto feed function by inserting and withdis-
the following pattern printed on one printing sheet.charging the document. In this mode, the feed of the document will be
1 Longitudinal stripe 2 Approx. 30 mmautomatically tested if the document is set.
2 black dots and 2 white dots are repeatedly progressed on 3. 11. Message print modeone
line.
Used to print the displayed message of communication for translate each
2 Full blackApprox. 30 mmlanguage.
3. 12. Ring & Dial free
1Used to reject dial tone check while autodialing is carried out. And used
to change the bottom Ring frequency of auto-receiving to 13Hz.
2
2 � 3 |
ACEC
SHARP
