132992330.qxd 4/30/03 2:10 PM Pagina 19 (Nero/Process Black pellicola)
cover and remove it. Always keep a rag nearby to dryClean the filter using a hard bristle brush.
up spillage of water when removing the cover.Tighten up the inlet hose.
Remove any objects from the pump impeller byThe dangers of freezing
rotating it.
If the machine is exposed to temperatures below 0°C,
certain precautions should be taken.
ITurn off the water tap.
IUnscrew the inlet hose.
IPlace the end of the emergency emptying hose and
that of the inlet hose in a bowl placed on the floor
and let water drain out.
IScrew the water inlet hose back on and reposition
Put the cap back on the emergency emptying hose andthe emergency emptying hose after having put the
place the latter back in its seat.cap on again.
IWhen you intend to start the machine up again,
make sure that the room temperature is above 0°C.
Important!
Every time you drain the water through the emergency
emptying hose you must pour 2 litres of water into the
main wash compartment of the detergent drawer and
then run the drain programme. This will activate the
ECO valve avoiding that part of the detergent remains
Screw the pump cover fully in.unused at next washing.
Close the pump door.
Emergency emptying out
WarningIf the water is not discharged, proceed as follows to
When the appliance is in use and depending on theempty out the machine:
programme selected there can be hot water in the pump. pull out the plug from the power socket;
Never remove the pump cover during a wash cycle, close the water tap;
always wait until the appliance has finished the cycle,
if necessary, wait until the water has cooled down;
and is empty. When replacing the cover, ensure it is open the pump door;
securely retightened so as to stop leaks and young
children being able to remove it. place a bowl on the floor and place the end of the
emergency emptying hose into the bowl. Remove its
Cleaning the water inlet filtercap. The water should drain by gravity into the bowl.
When the bowl is full, put the cap back on the hose.
If your water is very hard or contains traces of lime
deposit, the water inlet filter may become clogged.Empty the bowl. Repeat the procedure until water
stops flowing out;
It is therefore a good idea to clean it from time to time. clean the pump if necessary as previously described;
Turn off the water tap. Unscrew the water inlet hose.
replace the emergency emptying hose in its seat after
having plugged it;
screw the pump cover again and close the door.
19 |
ACEC
ZANUSSI
