General Information
Refer to the type plate on the rear or
Care and safety information
bottom of the system for identification
and supply ratings.(page 3 � P2)
Avoid high temperatures, moisture,English
Supplied accessories (page 3 � P1)water and dust
� Do not expose the system, batteries or discs
� USB PC LINK software installer CD-ROM
to humidity, rain, sand or excessive heat (caused
� USB cableby heating equipment or direct sunlight). Always
� Remote control and two AA batteries.
keep the disc tray closed to avoid dust on the
� AM loop antennalens.
� FM wire antenna
� Video cinch cable (yellow)Avoid condensation problem
� Mains plug adaptor (for version /21 only)� The lens may cloud over when the system is
� AC power cordsuddenly moved from cold to warm
surroundings, making it impossible to play a disc.
Leave the system in the warm environment until
the moisture evaporates.
Environmental information
All unnecessary packaging has been omitted.Do not block the vents
� In a cabinet, allows about 10cm (4 inches) of
We have tried to make the packaging easy to
separate into three materials: cardboard (box),free space all around the system for adequate
ventilation.
polystyrene foam (buffer) and polyethylene
(bags, protective foam sheet).Care of disc
� To clean a CD, wipe it in a straight line from
Your system consists of materials which can bethe centre towards the edge using a soft, lint-free
recycled and reused if disassembled by a
cloth. A cleaning agent may damage the disc!
specialised company. Please observe the local� Write only on the printed side of a CDR(W)
regulations regarding the disposal of packaging
and only with a soft felt-tipped pen.
materials, exhausted batteries and old� Handle the disc by its edge, do not touch the
equipment.
surface.
Care of the cabinet
� Use a soft cloth slightly moistened with a mild
detergent solution. Do not use a solution
containing alcohol, spirits, ammonia or abrasives.
Finding a suitable location
� Place the system on a flat, hard, and stable
surface.
Built-in safety circuit
� Under extreme conditions, this system may
switch to standby mode automatically. If this
happens, let the system cool down before
reusing it.
Power saving
� This system is designed to use less than 1W
of electricity when switches to Eco Power
standby. Disconnect the AC power cord from
the power outlet when not in use.
7 |
ACEC
PHILIPS
