CONTENTSGENERAL INFORMATIONSAFETY INFORMATION
Y If the system is brought directly from a
General Information .................5IMPORTANT:Accessories (Supplied)
cold to a warm location, or is placed in a
PLEASE NOTE THAT THE
� Remote controlEnglish
Safety Information ....................5VOLTAGE SELECTORvery damp room, moisture may
� Batteries (two AA size) for remote
condense on the lens of the CD unit
LOCATED AT THE REAR OFcontrol
Preparation .......................... 6 - 7inside the system. Should this occur, the
THIS SYSTEM IS PRESET AT
� AM loop antenna
CD player will not operate normally.
Controls............................... 8 - 10220V FROM THE FACTORY.� FM wire antenna
Leave the power on for about one hour
FOR COUNTRIES THAT� AC power cord
Operating The System ..... 10 - 12OPERATE AT 110V, PLEASEwith no disc in the system until normal
� SS-107 surround speakers
ADJUST TO 110V BEFORE YOUplayback is possible.
CD....................................... 13 - 15Y Electrostatic discharge may cause
SWITCH ON THE SYSTEM.
Safety Informationunexpected problems. See whether
Tuner.................................. 16 - 17
Y Before operating the system, check thatthese problems disappear if you unplug
Tape ................................... 17 - 18the operating voltage indicated on thethe AC power cord and plug it in again
General Information
typeplate (or the voltage indicationafter a few seconds.
AUX/CDR ...................................19Y The type plate (which contains theY To disconnect the system from the
beside the voltage selector) of your
serial number) is located at the rearsystem is identical with the voltage ofpower supply completely, remove
Karaoke.....................................19
of the system.your local power supply. If not, pleasethe AC power plug from the wall
Y Recording is permissible ifsocket.
Recording ......................... 20 - 21consult your dealer. The typeplate is
copyright or other rights of thirdlocated at the rear of your system.
Clock .........................................22parties are not infringed.
Y When the system is switched on, do not
move it around.
Timer................................. 22 - 23
Environmental InformationY Place the system on a solid base (e.g. a
Sleep Timer ..............................23cabinet).
All unnecessary packaging has been
Y Place the system in a location with
omitted. We have tried to make the
Specifications .........................24
packaging easy to separate into threeadequate ventilation to prevent internal
heat build-up in your system. Allow at
Maintenance............................25materials: cardboard (box), polystyrene
least 10 cm clearance from the rear and
foam (buffer) and polyethylene (bags,
Troubleshooting .............. 25 - 26protective foam sheet).the top of the unit and 5 cm from the
each side.
Your system consists of materials whichY Do not expose the system to excessive
can be recycled and reused if disassembledmoisture, rain, sand or heat sources.
by a specialized company. Please observeY Under no circumstances should you
the local regulations regarding the disposalrepair the system yourself, as this will
of packaging materials, exhaustedinvalidate the warranty!
batteries and old equipment.
5
Untitled-556/8/01, 10:26 AM3139 116 19751 |