TROUBLESHOOTING
EnglishWarning! Under no circumstancesNo or poor sound.Timer not working.
Radio Reception
you should try to repair the set yourselfY Volume is not turned up.Y Clock is not set.
Poor radio reception
as this will invalidate the guarantee.aAdjust VOLUME.aSet the clock.
Y The signal is too weak.
Do not open the set as there is a risk ofY The headphones are connected.Y Timer is not switched on.
aAdjust the antenna.aDisconnect the headphones.aPress CLOCK/TIMER to switch on the
electric shock.
aConnect an external antenna for betterY Speakers are not connected or aretimer.
Y If a fault occurs, check the points listed
reception.connected wrongly.Y Dubbing/recording is in progress.
below before taking the system for
Y The TV or VCR is too close to the stereoaCheck that the speakers are connectedaStop dubbing/recording.
repair.
system.correctly.
Y Should any problems persist after youClock setting is erased.
aSeparate the stereo system from the TVaMake sure the stripped speaker wire is
have made these checks, consult yourY There was a power failure.
or VCR.clamped.
nearest dealer or service center.aReset the clock.
ONO RDS TEXT� is displayed.Reversed left and right sound.System displays features
Y RDS text message is not available.Y Speakers are connected wrongly.
CD Player Operationautomatically; buttons flash
aSelect another RDS station.aCheck the speaker connections andcontinuously.
ONO DISC� is displayed.location.
Y Demonstration mode is switched on.
Y The disc is inserted upside down.
Lack of bass sound or apparentlyaPress and hold ? (on the system only)
aPlace CD with printed side up.Tape Deck Operation
imprecise physical location of musicalfor 5 seconds to switch off the
Y Moisture condensation at the lens.Recording or playback cannot be
instruments.demonstration.
aWait until lens has adjusted to normalmade or there is a decrease in audio
Y Speakers are connected wrongly.
room temperature.level.A howling sound at external source.
aCheck the speaker connection for
Y There is no disc in the CD tray.Y Dirty tape heads, capstans or pressureY You hear feedback when you are
proper phasing, red/black wires to red/
aInsert a CD.rollers.listening and recording from the same
Y The CD is dirty, badly scratched oraSee section on tape deck maintenance.black terminals.source simultaneously.
warped.Y Magnetic build-up in the record/Remote control has no effect on theaPress AUX to select CDR mode.
aClean or replace the CD.playback head.system.
Y The CD lens is dirty or dustyaUse demagnetizing tape.Y Wrong source is selected.All lighted buttons are not lit.
aSee section under Maintenance.aSelect the source (CD, TUNER, etc.)Y Equalizer Display is switched on in NITE
before pressing the function button,mode.
ODISC NOT FINALISED� isGeneral
(?, ?, ?, etc.).aRotate JOG to other Equalizer Display.
displayed.System does not react when any
Y The distance to the system is too large.
Y The CD-RW or CD-R disc is not properlybutton is pressed.
aReduce the distance.
recorded for the use of a standard CDY Electrostatic discharge.
Y Batteries are inserted incorrectly.
player.aPress STANDBY-ON to switch the
aInsert the batteries with their polarities
aRead the instruction booklet of your CD-system off. Remove the AC power plug
(+/� signs) as indicated.
Rewritable or CD-Recorder on how tofrom the wall outlet, then reconnect theY Batteries are exhausted.
finalize a recording.power plug and switch on the systemaReplace the batteries.
Y The CD is badly scratched or dirty.again.
26aReplace or clean CD. |
ACEC
PHILIPS
