CONTENTSGENERAL INFORMATIONSAFETY INFORMATION
Y If the system is brought directly from a
General Information ........................ 7General InformationAccessories (Supplied)
cold to a warm location, or is placed in a
� Remote controlEnglishY The typeplate (which contains the
Safety Information ........................... 7very damp room, moisture may
serial number) is located at the rear� Batteries (two AA size) for remote
condense on the lens of the CD unit
Preparation ................................. 8 - 9of the system.controlinside the system. Should this occur, the
Y Recording is permissible if� AM loop antenna
CD player will not operate normally.
Controls ................................... 10 - 12copyright or other rights of third� FM wire antenna
Leave the power on for about one hour
parties are not infringed.� AC power cord
Operating the system .............13 - 15with no disc in the system until normal
Y This device complies with the� CD Recorder
playback is possible.
CD ............................................. 15 - 17Federal CommunicationsY Electrostatic discharge may cause
Commission (FCC) rules, part 15 and
Safety Informationunexpected problems. See whether
CD Recorder.............................18 - 24with 21 CFR 1040.10. Operation is
Y Before operating the system, check thatthese problems disappear if you unplug
subjected to the following two
Tuner ................................................ 25the operating voltage indicated on thethe AC power cord and plug it in again
conditions:
typeplate (or the voltage indicationafter a few seconds.
Tape .................................................. 26� This device may not causeY To disconnect the system from the
beside the voltage selector) of your
harmful interference, and
system is identical with the voltage ofpower supply completely, remove
AUX/CDR.......................................... 27� This device must accept any
your local power supply. If not, pleasethe AC power plug from the wall
interference received, including
Recording .................................27 - 28consult your dealer. The typeplate issocket.
interference that may cause
located at the rear of your system.
Clock ................................................ 29undesired operation.
Y When the system is switched on, do not
move it around.
Timer .........................................29 - 30
Environmental InformationY Place the system on a solid base (e.g. a
Maintenance .................................. 30All unnecessary packaging has beencabinet).
omitted. We have tried to make theY Place the system in a location with
Specifications ................................ 31packaging easy to separate into threeadequate ventilation to prevent internal
materials: cardboard (box), polystyreneheat build-up in your system.
Troubleshooting ..................... 32 - 33
foam (buffer) and polyethylene (bags,Y The system incorporates a built-in
protective foam sheet).safety feature that prevents over
heating.
Your system consists of materials which
Y Do not expose the system to excessive
can be recycled and reused if disassembled
moisture, rain, sand or heat sources.
by a specialized company. Please observe
Y Under no circumstances should you
the local regulations regarding the disposal
repair the system yourself, as this will
of packaging materials, exhausted
invalidate the warranty!
batteries and old equipment.
7 |
ACEC
PHILIPS
