4 FAN AND FAN MOTOR6 DAMPER CONTROL
1) Remove freezer drawers.1) Remove the Cover Lamp, R and loosen 2 screw.
2) Remove two cap, screws and loosen two screws in Grille F2) Pull the Control Boan.x, R and separate the lead wire
3) Pull out the Grille Fan and Shroud, F.housing.
3) Remove the Cover Lamp, R.
4) Disconnect the housing of lead wire.
5) Separate the Fan Assy.4) Separate the Insulation Multi Duct and Control Box, R.
5) Disassemble the Knob.
6) Losse 2 screw fixed to the Bracket.
7) Pull out Shroud, F remove the Fan Motor Assy.6) Separate the Damper Control and Control Box, R.
8) Separate the Motor Bracket and Rubber.7) Separate the Damper Control and Resistor.
8) Disconnect the lead wire.
REFRIGERATOR ROOM LAMPFAN MOTOR
SHROUD
GUIDE FAN
FAN
GRILLE
Figure 11
Figure 13
5 DEFROST CONTROL ASSY
Defrost Control Assy consists of Thermistor and Fuse, Melting.
Thermistor functions to defrost automatically and it is attached to7 HEATER, SHEATH & HEATER, CORD-L
metal side of the Evaporator and senses temperature.In this refrigerator, Heater, Sheath & Heater, Cord-L are
Fuse, Melting is a kind of safety device for preventing overheatingused for defrosting heater. During heating, the temperature
of the Heater when defrosting. of heater rises about 300~350!C. Therefore, be careful not
to burn while servicing.
At the temperature of 77!C, it stops the emission of heat from the
Heater.1) After removing the Grille and Shroud, separate the
Heater, Sheath by disconnecting the connectors.
1) Pull out the Shroud, F after removing the Grille.
2) Separate the connector connected with the Defrost Control2) Exchanged Heater, Sheath and connected the housing.
Assy and replace new one.
Thermister
Fuse, Melting
Figure 12A
Heater, SheathHeater, SheathFigure 14A
Note: B has been only applied to europe area.
Thermister
Fuse, Melting
Figure 12B
Heater, SheathHeater, SheathFigure 14B
- 10 - |
ACEC
LG-GOLDSTAR
