EN 3
IMPORTANT PRODUCTANTENNA INSTALLATION
INSTRUCTIONS
SAFETY INSTRUCTIONS
1. Outdoor Antenna Grounding
Electrical energy can perform many useful functions. ButIf an outside antenna or cable system is connected
improper use can result in potential electrical shock or fire
to the product, be sure the antenna or cable system
hazards. This product has been engineered and
is grounded so as to provide some protection
manufactured to assure your personal safety. In order not to
against voltage surges and built-up static charges.
defeat the built-in safeguards, observe the following basic
Article 810 of the National Electrical Code, ANSI/rules for its installation, use and servicing.
NFPA 70, provides information with regard to
ATTENTION:proper grounding of the mast and supporting
Follow and obey all warnings and instructions marked onstructure, grounding of the lead-in wire to an
your product and its operating instructions. For your safety,antenna discharge unit, size of grounding conduc-
please read all the safety and operating instructions beforetors, location of antenna discharge unit, connection
you operate this product and keep this manual for future
to grounding electrodes, and
reference.
requirements for the grounding electrode.
2. Lightning
For added protection for this product during a
INSTALLATION
lightning storm, or when it is left unattended and
1. Power Sourcesunused for long periods of time, unplug it from the
Operate your product only from the type of powerwall outlet and disconnect the antenna or cable
source indicated on the marking label. If you aresystem. This will prevent damage to the product
not sure of the type of power supply to your home,due to lightning and power-line surges.
consult your product dealer or local power
3. Power Lines
company. If your product is intended to operate
An outside antenna system should not be located in
from battery power, or other sources, refer to the
the vicinity of overhead power lines or other
operating instructions.
electric light or power circuits, or where it can fall
2. Overloadinginto such power lines or circuits. When installing an
Do not overload wall outlets, extension cords, oroutside antenna system, extreme care should be
integral convenience receptacles as this can resulttaken to keep from touching such power lines or
in a risk of fire or electric shock.circuits as contact with them might be fatal.
3. Power Cord Protection
Power supply cords should be routed so that theyEXAMPLE OF ANTENNA GROUNDING AS PER
are not likely to be walked on or pinched by itemsNATIONAL ELECTRICAL CODE, ANSI/NFPA 70
placed upon or against them, paying particular
attention to cords at plugs, convenience recepta-
cles, and the point where they exit from theANTENNA
LEAD IN WIRE
product.
4. VentilationGROUND CLAMP
Slots and openings in the cabinet are provided for
ANTENNA
ventilation. To ensure reliable operation of the
DISCHARGE UNIT
product and to protect it from overheating, these(NEC SECTION
810-20)
openings must not be blocked or covered.ELECTRIC SERVICE
EQUIPMENT
YDo not block the openings by placing the productGROUNDING
CONDUCTORS
on a bed, sofa, rug or other similar surface.(NEC SECTION 810-21)
YDo not place the product in a built-in installation
GROUND CLAMPS
such as a bookcase or rack unless proper
POWER SERVICE GROUNDING ELECTRODE SYSTEM
ventilation is provided or the manufacturerOs(NEC ART 250. PART H)
instructions have been adhered to.NEC � NATIONAL ELECTRICAL CODE
5. Wall or Ceiling Mounting
The product should be mounted to a wall or ceiling
only as recommended by the manufacturer. |
ACEC
JVC
