EN 51
Audio dubbing indicatorAudio Dubbing
You can record a new soundtrack on a prerecorded tape
e4
M�0:05:20(normal audio only).
Perform steps 1, 2 and 3 of the Insert Editing procedure
(Z pg. 50) before continuing.
YThe sound comes from the built-in microphone.
FIND EDIT-IN POINT
Press REW to go a little beyond the beginning of the
1scene onto which you want to dub new audio, press
LCD monitor or viewfinder
PLAY to view the recorded tape, then press PAUSE
at exactly the point where dubbing should start.
MicrophoneENGAGE AUDIO DUB-STANDBY
MODE
Press and hold A. DUB, and without releasing
2A. DUB, press and release PAUSE.
BEGIN AUDIO DUBBING
Press PLAY. When the counter reaches O0:00:00�,
3Audio Dubbing stops automatically and the
camcorder enters the Audio Dub-Standby mode.
END AUDIO DUBBING
Press STOP.
4
REW
PLAY
NOTES:
PAUSEcDo not press FF or REW during Audio Dub-Standby, or
REWthe edit points will not be accurate.
cIf the microphone is too close to the TV, or if the TVOs
A. DUBvolume is too high, whistling or howling may occur.
RM-V700URM-V705U
OR
(optional)(provided)NOTES (for Insert Editing and
Audio Dubbing):
cInsert Editing and audio Dubbing may not work
correctly if the tape contains blank segments, or if the
recording speed was changed during the original
recording.
cTo edit/dub onto a tape, make sure the Erase Protection
tab is in the position that allows recording. If not, slide
the tab. Some cassettes have removable tabs. If the tab
has been removed, cover the hole with adhesive tape.
cDo not press STOP during Insert Editing or Audio
Dubbing, or the edit points will not be accurate.
cDuring Insert Editing and Audio Dubbing, when Insert-
Pause or Audio Dub-Standby is engaged, the counter
may go slightly past O0:00:00�. Recording, however,
stops at exactly 0:00:00. |
ACEC
JVC
