MasterPage: Start_Right
GR-D350UC.book Page 37 Wednesday, October 19, 2005 1:51 PM
TROUBLESHOOTINGEN 37
Picture does not appear on the LCD TAPE!
monitor.Appears if a tape is not loaded when the
I The viewŢnder is pulled out and OPRIORITY� is Recording Start/Stop Button or SNAPSHOT
set to OFINDER�.Button is pressed while the Power Switch is set
�Push the viewŢnder back in or set OPRIORITY� to to OREC�.
OLCD�. ( pg. 18, 22, 24)
I The LCD monitorOs brightness setting is too dark.TAPE END
�Adjust the brightness of the LCD monitor.
( pg. 15)Appears when the tape ends during recording or
playback.
�If the monitor is tilted upward 180 degrees, open
the monitor fully. ( pg. 18)
SET DATE/TIME!
An error indication (01 � 04 or 06) appears.÷ Appears when the date/time is not set.
I A malfunction of some kind has occurred. In this ( pg. 14)
case the camcorderOs functions become ÷ The built-in clock battery has run out and the
unusable.previously set date/time has been erased.
� pg. 37.Consult your nearest JVC dealer for
replacement.
Warning Indications
LENS CAP
Appears for 5 seconds after power is turned on if
the lens cap is attached or when it is dark.
Displays the battery remaining power.
Remaining power levelHDV
HighExhaustedAppears when pictures recorded in the HDV
As the battery power comes close to nil, the format are detected. The pictures in the HDV
battery remaining power indicator blinks.format cannot be played back with this
When the battery power is exhausted, power camcorder.
turns off automatically.
UNIT IN SAFEGUARD MODE
REMOVE AND REATTACH BATTERY
OR DC PLUG
I Appears if a tape is loaded. ( pg. 16)
I Blinks when no tape is loaded. ( pg. 16)The error indications (01, 02 or 06) show what
type of malfunction has occurred. When an error REFERENCES
CHECK TAPEOS ERASE PROTECTION TABindication appears, the camcorder turns off
Appears when the erase protection tab is set to automatically. Remove the power supply
OSAVE� while the Power Switch is set to OREC�. (battery, etc.) and wait a few minutes for the
( pg. 13)indication to clear. When it does, you can
resume using the camcorder. If the indication
USE CLEANING CASSETTEremains, consult your nearest JVC dealer.
Appears if dirt is detected on the heads during
UNIT IN SAFEGUARD MODE
recording. Use an optional cleaning cassette.
EJECT AND REINSERT TAPE
( pg. 40)
The error indications (03 or 04) show what type
CONDENSATION, OPERATION of malfunction has occurred. When an error
PAUSED PLEASE WAITindication appears, the camcorder turns off
automatically. Eject the cassette once and re-
Appears if condensation occurs. When this
insert it, then check if the indication clears.
indication is displayed, wait more than 1 hour
When it does, you can resume using the
until condensation disappears.
camcorder. If the indication remains, consult
your nearest JVC dealer. |
ACEC
JVC
