EN29
Menu Screen Explanations
FADER/WIPERefer to OFade/Wipe Effects� ( pg. 34, 35).
PROGRAM AERefer to OProgram AE With Special Effects� ( pg. 36, 37).
W.BALANCERefer to OWhite Balance Adjustment� and OManual White Balance
Operation� ( pg. 39).
REC MODEAllows you to set the video recording mode (SP or LP) depending on your
pre-ference ( pg. 15).
SOUND12 BITEnables video recording of stereo sound on four separate channels, and is
MODErecommended for use when performing audio dubbing. (Equivalent to the 32
kHz mode of previous models)
16 BITEnables video recording of stereo sound on two separate channels. (Equiva-
lent to the 48 kHz mode of previous models)
ZOOM10XWhen set to O10X� while using digital zoom, the zoom magnification will
reset to 10X since digital zoom will be disengaged.
40XAllows you to use the Digital Zoom. By digitally processing and magnifying
images, zooming is possible from 10X (the optical zoom limit), to a maximum
of 40X digital magnification.
300XAllows you to use the Digital Zoom. By digitally processing and magnifying
images, zooming is possible from 10X (the optical zoom limit), to a maximum
CAMERAof 300X digital magnification.
SNAP MODERefer to OSnapshot (For Video Recording)� ( pg. 20).
GAIN UP OFFAllows you to shoot dark scenes with no picture brightness adjustment.
AGCThe overall appearance may be grainy, but the image is bright.
AUTOThe shutter speed is automatically adjusted (1/30 N 1/200 sec.). Shooting a
subject in low or poor lighting at 1/30 sec. shutter speed provides a brighter
image than in the AGC mode, but the subjectOs movements are not smooth or
natural. The overall appearance may be grainy. While the shutter speed is
being automatically adjusted, O� is displayed.
CAMERA VIDEOEnables regular video shooting.
DUALEnables ODual Shooting� ( pg. 26).MODE
PS-VIDEO Enables OProgressive Mode Recording� ( pg. 24).
DISOFFTo compensate for unstable images caused by camera-shake, particularly at
high magnification.
NOTES:
I Accurate stabilization may not be possible if hand shake is excessive, or
under the following conditions:
YWhen shooting subjects with vertical or horizontal stripes.
ON YWhen shooting dark or dim subjects.
YWhen shooting subjects with excessive backlighting. MANUAL
YWhen shooting scenes with movement in various directions.
YWhen shooting scenes with low-contrast backgrounds.
I Switch off this mode when recording with the camcorder on a tripod.
I The O� indicator blinks or goes out if the Stabilizer cannot be used.
: Factory-preset
NOTES:
IThe O CAMERA� settings are effective when the Power Switch is set to both O� and O�.
IThe O MANUAL� settings are effective only when the Power Switch is set to O �.
CONTINUED ON NEXT PAGE |
ACEC
JVC
