RECORDING Advanced Features (cont.)
22 EN
Fade/Wipe EffectsFADE/WIPE SELECTION (, , , ,
, , , , , and )
These effects let you make pro-style scene
transitions. Use them to spice up the transitionFade or Wipe works when recording is started or when
from one scene to the next. You can also varyyou stop recording.
transitions from scene to scene.
Set the Power Switch to O �.
IMPORTANT:1
Some Fade/Wipe Effects cannot be used with
certain modes of Programme AE with specialPress MENU/BRIGHT. The Recording Menu appears.
effects (Z pg. 24). If an unusable Fade/Wipe2
Effect is selected, its indicator blinks.
Rotate MENU/BRIGHT to move the highlight bar to
3OFADER/WIPE�, then press it.
MENU/BRIGHT Dial
Rotate MENU/BRIGHT to move the highlight bar to
4the desired function, then press it.
YThe FADER/WIPE Menu disappears and the effect is
reserved. The indicator representing the selected
effect appears.
Power SwitchPress the Recording Start/Stop Button to activate the
5Fade-in/out or Wipe-in/out.
PICTURE WIPE OR DISSOLVE SELECTION
(, , , , , and )
Recording Start/Stop ButtonThe Picture Wipe or Dissolve works when recording is
started.
Follow steps 1 through 4 above.
1
Engage the Record-Standby mode.
2
If you select Picture Wipe/Dissolve during
recording . . .
.... press the Recording Start/Stop Button when one
scene is finished. The point at which the scene
ended is stored in memory.
If you select Picture Wipe/Dissolve during Record-
Standby mode . . .
NOTES:.... press the Recording Start/Stop Button to start
cYou can extend the length of a Fade or Wiperecording and press it again when one scene is
by pressing and holding the Recording Start/finished. The point at which the scene ended is
Stop Button.stored in memory.
cIf the power is turned off after a scene isIf you select Picture Wipe/Dissolve during Record-
finished recording, the stored point is erased,Standby mode after performing a Picture Wipe/
disabling the Picture Wipe/Dissolve combina-Dissolve . . .
tion. When this happens, the Picture Wipe/.... the point at which the scene ended is already
Dissolve indicator blinks. Also note thatstored in memory.
power shuts off automatically if 5 minutes
elapse in the Record-Standby mode.If you start recording a new scene within 5 minutes of
cThe sound at the end of the last recorded3the end of the previous recording (without having
scene is not stored.turned the camcorderOs power off), the previous scene
wipes out, revealing the new scene. |
ACEC
JVC
