5.5a Guide roller (SUPPLY) assembly/ 5b Rail assembly
Note 5a:
5a
When removing the rail assembly, remove the guide roller
Note 5a(SUPPLY) assembly beforehand.
(P5)
Note 5b
(W5)Note 5b:
Note 5cPay careful attention to the spring not to lose it.
(W5)
5b
(W5)Note 5c:
Pay careful attention to the engagement of the rail assemblyOs
arm ends because they easily come off the engagement.
Moreover, make sure that there is neither deformation nor
damage observed in them.
Note 5d:
Note 5d
When removing the rail assembly, check to see if the collar
is securely set in the arm groove.
Fig. 5
6.B Slide deck assembly/ C Main deck assembly
Note 6a:
(L6a)(W6)When removing the slide deck assembly, pay heed to the
BSlide deck assemblythree components of the following because they are apt to
come off after the slide deck assembly is removed.
Tension lever assembly/ 8a 8b Slide lever assembly
8c Brake control lever assembly
For reassembling those components, refer to Fig. 8 on page
2-10.
Note 6b:
When reassembling the slide deck assembly to the main deck
Note 6bassembly, combine them with each other by the side grooves
and then slide the slide deck assembly by 1 mm or so.
(L6b)
1mm
CMain deck
Note 6a
assembly
(L6c)
(L6d)
Fig. 6
2-9 |
ACEC
JVC
