RECORDING Advanced Features For Video And D.S.C. (cont.)
38 EN
Fade/Wipe EffectsFADE/WIPE SELECTION (, , , ,
, , , , and )
These effects let you make pro-style scene
transitions. Use them to spice up the transitionFade or Wipe works when recording is started or when
from one scene to the next. You can also varyyou stop recording.
transitions from scene to scene.
Set the Shooting Mode Dial to OVIDEO� or OPS� then
IMPORTANT:1set the Power Switch to O � while pressing down
Some Fade/Wipe Effects cannot be used withthe Lock Button located on the switch. Pull out the
certain modes of Programme AE with specialviewfinder fully or open the LCD monitor fully.
effects (Z pg. 40, 41). If an unusable Fade/
Wipe Effect is selected, its indicator blinks orPress MENU/BRIGHT. The Menu Screen appears.
goes out.2
Shooting Mode DialRotate MENU/BRIGHT to select O�, then press it.
3
PSRotate MENU/BRIGHT to select the desired function,
VIDEO4then press it. Selection is complete.
DUALXGAYThe FADER/WIPE Menu disappears and the effect is
VGA
reserved. The indicator representing the selected
effect appears.
Press the Recording Start/Stop Button to activate the
5Fade-in/out or Wipe-in/out.
MENU/BRIGHT
WheelPICTURE WIPE OR DISSOLVE SELECTION
(, , , , , and )
The Picture Wipe or Dissolve works when recording is
started.
Follow steps 1 through 4 above.
1
Power Switch
If you select Picture Wipe/Dissolve during
Recording Start/Stop Button
2recording . . .
.... press the Recording Start/Stop Button when one
scene is finished. The point at which the scene
To Deactivate The Selected Effect . . .
ended is stored in memory.
.... select OOFF� in step 4.
If you select Picture Wipe/Dissolve during Record-
NOTES:Standby mode . . .
cYou can extend the length of a Fade or Wipe.... press the Recording Start/Stop Button to start
by pressing and holding the Recording Start/recording and press it again when one scene is
Stop Button.finished. The point at which the scene ended is
cIf the power is turned off after a scene isstored in memory.
finished recording, the stored point is erased,
If you select Picture Wipe/Dissolve during Record-
disabling the Picture Wipe/Dissolve combina-
Standby mode after performing a Picture Wipe/
tion. When this happens, the Picture Wipe/
Dissolve . . .
Dissolve indicator blinks. Also note that
.... the point at which the scene ended is already
power shuts off automatically if 5 minutes
stored in memory.
elapse in the Record-Standby mode.
cPicture Wipe/Dissolve cannot be used when
If you start recording a new scene within 5 minutes of
the Shooting Mode Dial is set to OPS�.
3the end of the previous recording (without having
cAll Fade/Wipe Effects cannot be used when
turned the camcorderOs power off), the previous scene
the Shooting Mode Dial is set to ODUAL�.
wipes out, revealing the new scene.
cThe sound at the end of the last recorded
scene is not stored. |
ACEC
JVC
