Master Page: Right
GR-DVX707EG_80-103.fm Page 89 Thursday, January 31, 2002 12:47 PM
EN 89
Memory Cards...in places subject to excessive shock or
vibration.
To properly use and store your memory cards, be ...near a television set.
sure to read the following cautions:...near appliances generating strong magnetic or
1. During use?electric fields (speakers, broadcasting
...make sure the memory card bears the SD or antennas, etc.).
MultiMediaCard mark....in places subject to extremely high (over 40°C)
...make sure the memory card is positioned or extremely low (under 0°C) temperatures.
properly when inserting.3. DO NOT leave the unit?
2. While the memory card is being accessed ...in places of over 50°C.
(during recording, playback, deletion, ...in places where humidity is extremely low
initialisation, etc.)?(below 35%) or extremely high (above 80%).
...never unload the memory card and never turn ...in direct sunlight.
off the camcorder....in a closed car in summer.
3. Store memory cards?...near a heater.
...away from heaters or other heat sources.4. To protect the unit, DO NOT?
...out of direct sunlight....allow it to become wet.
...where they won?t be subject to unnecessary ...drop the unit or strike it against hard objects.
shock or vibration....subject it to shock or excessive vibration
...where they won?t be exposed to strong during transportation.
magnetic fields (such as those generated by ...keep the lens directed at extremely bright
motors, transformers or magnets).objects for long periods.
...expose the lens to direct sunlight.
LCD Monitor...carry it by holding the LCD monitor or the
viewfinder.
1. To prevent damage to the LCD monitor,...swing it excessively when using the hand strap
DO NOT?or the grip.
...push it strongly or apply any shocks....swing the soft camera case excessively when
...place the camcorder with the LCD monitor on the camcorder is inside it.
the bottom.5. Dirty heads can cause the following problems:
2. To prolong service life . . .
...avoid rubbing it with coarse cloth.
3. Be aware of the following phenomena for LCD
monitor use.
These are not malfunctions:
While using the camcorder, the surface around
the LCD monitor and/or the back of the LCD
monitor may heat up.
No picture during playback.
If you leave power on for a long time, the
surface around the LCD monitor becomes hot.Blocks of noise appear during playback.
During recording or playback, the Head Clog
Warning indicator ? ? appears.
Main UnitRecording cannot be performed properly.
In such cases, use an optional cleaning cassette.
1. For safety, DO NOT?Insert it and play back. If the cassette is used more
...open the camcorder?s chassis.
than once consecutively, damage to the video heads
...disassemble or modify the unit.may result. After the camcorder plays back for about
...short-circuit the terminals of the battery pack.
Keep it away from metallic objects when not in 20 seconds, it stops automatically. Also refer to the
cleaning cassette?s instructions.
use.If, after using the cleaning cassette, the problems still
...allow inflammables, water or metallic objects
exist, consult your nearest JVC dealer.
to enter the unit.Mechanical moving parts used to move the video
...remove the battery pack or disconnect the
power supply while the power is on.heads and video tape tend to become dirty and
worn out over time. In order to maintain a clear
...leave the battery pack attached when the picture at all times, periodic check-ups are
camcorder is not in use.
recommended after using the unit for about 1,000
2. Avoid using the unit?hours. For periodic check-ups please consult your
...in places subject to excessive humidity or dust.
...in places subject to soot or steam such as near nearest JVC dealer.
a cooking stove.
GR-DVX707EG_80-103.fmPage 89 |
ACEC
JVC
