Master Page: Right
GR-DVX707EG_37-79.fm Page 75 Thursday, January 31, 2002 12:19 PM
EN 75
Select ScenesI Cycle through the effects by pressing
repeatedly, and stop when the one you want is
Remote sensordisplayed.
I If you select a Wipe/Fader effect for an Edit-Out
point, the effect is automatically applied to the
following Edit-In point.
I When you use Wipe/Fader effects, that time is
included in the total time.
11If using Playback Special Effects, press EFFECT.
( pg. 69)
12Repeat steps8 through 11 to register
additional scenes.
I To change previously registered points, press
CANCEL on the remote control. The registered
points disappear, one at a time, from the most
recently registered point.
I If you are not using Wipe/Fader or Program AE
with special effects, repeat steps 8 and 9 only.
NOTES:
I When choosing a scene, set Edit-In and Edit-Out
points so that there is a relatively large difference
between them.
PLAY
FADE/WIPEI If the search time for an in-point exceeds
EFFECT5 minutes, the recording deck?s Record-Standby
EDIT IN/OUTR.A.EDITmode will be cancelled and editing will not take
ON/OFFplace.
I If there are blank portions before or after the Edit-
CANCELIn and Edit-Out points, a blue screen may be
included in the edited version.
6Point the remote control at the camcorder?s I Since time codes register time only as accurately
remote sensor. Press PLAY (U) and then press as seconds, the time code total time may not
R.A.EDIT ON/OFF on the remote control.match the total program time exactly.
The Random Assemble Editing Menu appears.I Turning off the camcorder?s power erases all
registered Edit-In and Edit-Out points.
Selected parameterI If you select Sepia or Monotone mode from
Program AE with special effects, you cannot use
IONUTMODERandom Assemble the Black & White Fader. In this case the Black &
1-- --:-- ~Editing MenuWhite indicator begins blinking. Once the next
2~
3~Edit-In point is registered, the effect is turned off.
4~To combine these effects, use Sepia or Monotone
5~
6~during recording, then use the Black & White
7~Fader during Random Assemble Editing.
8~
TIME CODE--:--I It is not possible to use Wipe/Fader effects and
TOTAL00:00Program AE with special effects during Random
7If using a Wipe/Fader at the beginning of the Assemble Editing using a DV cable.
scene, press FADE/WIPE on the remote control.
I Cycle through the effects by pressing
repeatedly, and stop when the one you want is
displayed.
8At the beginning of the scene, press EDIT IN/
OUT on the remote control. The Edit-In position
appears in the Random Assemble Editing Menu.
9At the end of the scene, press EDIT IN/OUT. The
Edit-Out position appears in the Random
Assemble Editing Menu.
10If using a Wipe/Fader at the end of the scene,
press FADE/WIPE.
CONTINUED ON NEXT PAGE
GR-DVX707EG_37-79.fmPage 75 |
ACEC
JVC
