Master Page: Left
GR-PD1PAL.book Page 12 Tuesday, June 17, 2003 7:31 PM
12 EN
Grip AdjustmentTripod Mounting
1Adjust the velcro strip.To attach the camcorder to a tripod, align the
2Pass your right hand through the loop and grasp direction stud and screw to the mounting socket and
the grip.stud hole on the camcorder. Then tighten the screw
clockwise.
3Adjust your thumb and fingers through the grip to I Some tripods are not equipped with studs.
easily operate the Recording Start/Stop Button,
Power Switch, SNAPSHOT and Power Zoom
Switch. Be sure to fasten the velcro strip to your
preference.
CAUTION:
When attaching the camcorder to a tripod, extend
NOTE:its legs to stabilise the camcorder. It is not advised
The grip can rotate 90o downward. It is useful to to use small sized tripods. This may cause damage
shoot images below. to the unit by falling over.
LCD Monitor And Viewfinder
While using the LCD monitor:
Make sure the viewfinder is pushed back in. Press
PUSH OPEN and open the LCD monitor fully. It can
rotate 270o (90o downward, 180o upward).
While using the viewfinder:
Make sure the LCD monitor is closed and locked.
Pull out the viewfinder fully.
I Be sure to pull out the viewfinder until you hear a
click, otherwise it may be pushed back in during
use.
180u
PUSH OPEN Button |
ACEC
JVC
