10 ENGETTING STARTED (cont.)
SlotClock (Lithium) Battery Insertion/Removal
This battery is necessary for clock operation and to
perform date/time settings.
Switch off the unitOs power and remove the power
1supply unit (battery pack, AC Power Adapter/Battery
Charger, etc.).
Pull out the battery holder to remove it from the
2camcorder.
Battery holder
Insert the battery in the holder, and be sure to have
3the O+� mark visible.
Slide the holder back into the slot until you hear a
4click.
NOTES:
cSee OSAFETY PRECAUTIONS� (Z pg. 2) for information
on safe handling of lithium batteries.
Cassette holder
cTo avoid losing the battery and/or battery holder, place
the camcorder with the grip side up as shown in the
illustration when inserting/removing the battery.
Loading/Unloading A Cassette
Open the LCD monitor fully (GR-SXM320 only).
1
Slide EJECT until the cassette holder opens. Do not
2use force to open.
PUSH ButtonEJECT Switch
Insert or remove a cassette. When inserting, make
Cassette holder
3sure the label is facing outward.
Press PUSH to close the cassette holder until it locks
4into place.
Close the LCD monitor (GR-SXM320 only).
5
NOTES:
cClosing the LCD monitor while the cassette holder is still
open may cause damage to the LCD monitor
PUSH ButtonEJECT Switch(GR-SXM320 only).
cThe cassette holder canOt be opened unless a power
supply is attached.
cMake sure that the tape is not slack when loading the
cassette. If there is any slack, turn the gear on the
cassette in the direction of the arrow to take up the
Turn to takeslack.
up slack.cMake sure the Erase Protection tab is in the position that
allows recording. If not, slide the tab. Some cassettes
have removable tabs. If the tab has been removed, cover
Erase Protection tabGear
the hole with adhesive tape.
cThe cassette holder cannot be opened while the
camcorder is in the record mode. |
ACEC
JVC
