2.5 CHECKUP AND ADJUSTMENT OF MECHANISM PHASE
<Connect gear> (Note 2)
Set the connect gear so
<Rotary encoder>that its locating hole meets
Set the O� of the rotary
part at the tapped hole the hole on the main deck
as shown in the figure.assembly.
<Worm wheel> (Note 2)
Set the worm wheel so
that its locating hole
meets the hole on the
main deck assembly.<Sub cam gear>
Set the sub cam gear
so that its locating hole
meets the hole on the
main deck assembly.Note 1
This state represents
<Main cam gear that the mechanism is
/Brake control plate>in the EJECT mode,
After fitting the main camwhich is the Omechanism
gear and brake control plat<Connect gear 2> (Note 2)assembly mode�.
together,set them togetherSet the connect gear 2 so
so that their locating holes
that its locating hole meets
meet the hole on the main the hole on the main deck
deck assembly.assembly.
Note 1:Note 2:
Since the connect gear 2 is tightly fixed to the main deckThe part that needs phase adjustment by the hole on the main
by caulking, adjust its phase with the connect gear anddeck assembly must exactly be set as the specified phase.
sub cam gear.There is a fear that some part is installed in a wrong phase
because assembling of the mechanism is automated. If so,
set every part in the correct phase whenever the mechanism
is reassembled.
Fig. 2-5-1
2-15 |
ACEC
JVC
