How to use the dishwasherUpper and lower rack
1. After loading the dishwasher, cl6.osOnce the te he Start indicator lamp haCrocs kery holders:Lower rack
door properly and open the water switched off press the On/Off buttoDn to own: cups and long-stemmed glasses.
supply tap.switch the dishwasher o All the ff.Up: plates.B
2. Press the On/Off button to switch theindica tor lamps switch off.A
dishwasher onOne of the . 7. Open the door (warning: beware of hot
programme indicator lamps will steam). Unload the lower rack before
switch on.the upper one. Close the water tap.
3. Select the desired programme by Upper rack
pressing the corresponding button.
The corresponding indicator lamp C
lights up.If re quired, select options
?Vario Organizer? multi-purpose support :
(if supplied).
4. Press the Start button to start the To be used, for example, forPlate holders:
long-handled uten(asilsrra nge
selected programmThe Start e. knives with the blade facing May be lowered to increase
indicator lamp will li Once seght up.t,
downwards), cups and glasses.available spaceA). (
the programmed data cannot be
altered by pressing the programme May be used in three different May be removed to increase
selector buttons.positions (see also ?Dishwasher available spaceB). T ( o remove:
loading instructions? on Page 4).pull the handle up.
Note: Once the Start button has been
pressed, the dishwasher memorises the 1. Upon the left-hand side of the rack.B
last programme selected. This 2. Upside-down, towards the centre of
information remains in the memory even the rack.A
during interruption of the power supply.
3. Upside-down, towards the left side.
To change the selected programme,
press the Start button for about
5 seconds, until the Start indicator
lamp switches oSelect a new ff.
programme using the programme Cutlery basket:
selector knob and press the Start
button.The cutlery basket can be removed to
increaseC () available space.
Note: If the dishwasher is switched off
during a wash programme, when
switched on again it will resuRameck h the eight adjustment:Glass holder:C
wash cycle from where it was (The dishwasher is delivered with the upper
interrupted.rack in the top position).
Only open the dishwasher doorTh ife ra ck height can also be changed
strictly necessary during a waswhhen cycl loade ed.
and exercise maximum caution. ? To lower: pull out two the side
Danger of scalding from steam.handles and gently lower the rack.
5. To indicate the end of the programmTo raise: pue, ll up the two side handles
the Start indicator lamp switches ofuntil thef rack clicks into place.
and the End indicator lamp (if fitted) The rack must be level on both
lights up(for a bout 30 m.in.)sides.
Please read the user instructions carefully. |
ACEC
BAUKNECHT
