How to use the dishwasherUpper and lower rack
1. After loading the dishwasher, c6.losOne thece th e Start indicator lamp has To raise: pull up thetwo side h andles Lower rack
door properly and open the water switched off press the On/Off buttuntil theon to rack clicks into place.
supply tap.switch the dishwasher o All theff. The rack must be level on both
B
2. Press the On/Off button to switchindic the ator lamps switch off.sides.
dishwasher oOnn.e o f the programme 7. Open the door (warning: beware of hoCrockert y Holders:A
Down: cups and long-stemmed glasses.
indicator lamps will switch on.steam). Unload the lower rack before
3. Select the desired programme by the upper one. Close the water tap Up: plates..
pressing the correspondingThe bu tton. Upper rack
corresponding indicator lamp lights
up. If required, select options (if supplied).C
4. Press the Start button to start the
selected programmThee. Start
indicator lamp will light upOnce se. t, Half Load:
the programmed data cannot be
Loading the lower rack only gives
"Vario Organi?zer multi-purpose
altered by pressing the programme
support:greater washing power, especially for
selector buttons.
To be used, for example, for loplang-tes and saucepans.
Note: Once the Start button has been
handled utens(ailsrra nge knives Plate holders:
pressed, the dishwasher memorises the
with the blade facing downwar ds),May be lowered to increase
last programme selected. This cups and glasses.
available spacA).e (
information remains in the memoryHalf Load: even May be used in three different
May be removed to increase available
during interruption of the power suppIf only the upply.er rack loaded is to rembeo ve positions (see ?Dishwasher also
spaceB(). To remove: pull the handle
To change the selected the cutlery basket from the lower rack and loading instructi? onons Page 4).
up.
programme, press the Start place it in the upper one.1. Upon the left-hand side of the rack.
button for about 5 seuntil conds, 2. Upside-down, towards the centre of B
the Start indicator lamp the rack.
A
switches off. Sel ect a new 3. Upside-down, towards the left side.
programme using the
programme selector knob and
press the Start button.
Note: If the dishwasher is switched off
during a wash programme, when
switched on again it will resume the wash Cutlery basket:
cycle from where it was interrupted.
The cutlery basket can be removed to
Only open the dishwasher door if increaseC () available space.
strictly necessary during a wash
cycle and exercise maximum Rack height adjustment:Glass holder:C
caution. Danger of scaldin(The dishwasg from her is delivered with the upper
steam.rack in the top position).
5. To indicate the end of the progThrame rameck, height can also be changed
the Start indicator lamp switchewhens off loaded.
and the End indicator lamp (if fi tted) To lower: pull ou twt to sihede
switches on(for a bout 30 min. .)handles and gently lower the rack.
Please read the user instructions carefully. |
ACEC
BAUKNECHT
