HOW TO USE THE DISHWASHER
Close the dishwasher door and turn on the
water tap.
1. Switch on the dishwasher and select the
programme. Select the programme required
by turning theprogramme selec tor knob.
The corresponding indicator lamp will 1
illuminate.
If required, select any additional functions.
2. Press the Start button to start the selected
wash programme. ThStarte indicator lamp
will illuminate. Once set the programmed data
cannot be altered by turning the programme
selector knob or pressing the buttons.2
Note: Once the Start button has been pressed,
the dishwasher memorises all the programme
selected. The selected programmes are also
saved in the event of power failure.
3. To change the programme selected, press the
Start button for about 5 seconds until the
Start indicator lamp switches off. Selec3t a new
programme using the programmeselector
knob and press tStart he button again.
The End indicator lamp (if fitted) iIluminates
briefly and th Stare t
4. Turn the programme selector knob anti-
clockwise to? the 0? position (only after the
End indicator lamp has switched on or the
Star indicator lampt has switched off). All the 4
indicator lamps switch off.
Note: If the dishwasher is switched off
during a wash programm, when switched on
again the dishwasher resumes the wash
cycle from where it was interrupted.
Open the door and unload first the lower rack
and then the upper one.
17 |
ACEC
BAUKNECHT
