3-2. INITIALIZATION OF D, C PAGE DATA
1. Initializing the D Page Data3. D Page Table
Note:If the page D data is initialized, the following adjustments must beNote:Fixed data-1 : Initialized data. ( Refer to O1. Initializing the D Page
performed again.Data�.)
1) Modification of D page dataFixed data-2 : Modified data. (Refer to O2. Modification of D PAGE
2) Clock adjustments of the video system adjustmentsData�).
3) Base band block adjustments of the video system adjustments
4) LCD system adjustments
Initial value
5) IR transmitter adjustmentsAddressRemark
6) Battery end adjustmentNTSCPAL
00 to 0F
Adjusting pageD100000Test mode
Adjusting Address00 to FF110000
12Fixed data-1
Initializing Method:13Fixed data-2
1) Select page: 0, address: 01, and set data: 01.14(Modified data, copy the data built in
2) Select page: 2, address: 00, and set data: 2D, and press the
15the same model.)
PAUSE button of the adjustment remote commander.
16Fixed data-1
3) Select page: 2, address: 01, set data: 2D, and press the PAUSE
17(Initialized data)
button.
4) Select page: 2, address: 02, and check that the data is O01�.18
5) Select page: 0, address: 01, and set data: 00.19Fixed data-2
6) Perform OModification of D Page Data�.1A
1BFixed data-1
2. Modification of D Page Data
1C
If the D Page data has been initialized, change the data of the OFixed
1DFixed data-2
data-2� address shown in the following tables by manual input.
1EFixed data-1
Modifying Method:1FFixed data-2
1) Before changing the data, select page: 0, address: 01, and set20Fixed data-1
data: 01.
21(Initialized data)
2) New data for changing are not shown in the tables because
22
they are different in destination. When changing the data, copy
23
the data built in the same model.
Note:If copy the data built in the different model, the camcorder24
may not operate.25
3) When changing the data, press the PAUSE button of the
26
adjustment remote commander each time when setting new
27
data to write the data in the non-volatile memory.
287070Battery end adj.
4) Check that the data of adjustment addresses is the initial value.
If not, change the data to the initial value.297777
5) After changing the data, select page: 0, address: 01, and set2AA0A0
data: 00.2BADAD
2CC0C0
2DFixed data-1
2E
2F
30Fixed data-2
31Fixed data-1
32Fixed data-2
33
34
35
36Fixed data-1
377070Battery end adj.
38Fixed data-2
39Fixed data-1
3A
3B
3CFixed data-2
3DFixed data-1
3EFixed data-2
3F
5-7 |
ACEC
SONY
