English
Important
YRead these instructions carefully in conjunction with the illustrations before using the
appliance for the first time. Keep these instructions for future reference.
YDo not use this appliance to heat or boil liquids other than water.
YThis kettle has a safety cut-out which protects it against overheating due to operation with
insufficient water. If the kettle ever runs dry, switch it off and allow 10 minutes to cool
down, then refill with cold water. The safety cut-out will automatically reset. Subsequently
you can switch the kettle on again.
YPlace the base unit of the kettle on a cool and firm, level surface.
YNever immerse the kettle or the base unit in water.
YIf the kettle is tipped back too far, water will spill through the back cover. Though the kettle
will still be electrically safe, extra care must be taken if it contains hot or boiling water.
YWARNING: If the kettle is overfilled there is a risk that boiling water will be ejected from the
spout.
YPrevent children from pulling the mains cord. Do not let the cord hang over the edge of the
work surface.
YPour away the very first water boiled. The kettle is then ready for use.
YThe kettle must only be used with the base unit supplied.
YDo not touch the heating element while it is hot.
YIf the supply cord becomes damaged, it must only be replaced by an authorised Philips
service representative as special tools and/or parts are required.
General description(fig. 1)Do notfill the kettle with less than 0.10 Iitre(up
to ?MIN? indication) to prevent the kettle from
A Water level indicators(2)running dry while operating.
B Lid
C On/Off switchDo notfill the kettle with more than 1.5 litre(up
D Pilot lightto ?MAX? indication) to prevent water being
E Base unitejected from the spout while boiling.
F OFilterline� scale filter
G Heating elementSwitching on
- Place the kettle on the base unit (E) (fig. 4).
- Switch the kettle on (fig. 5). The pilot light (D)
Cord storagewill come on.
- For safety and convenience, the free length ofSwitching off
the mains cord can be reduced by pushing the- The kettle will switch off automatically once the
cord inside the base unit (see fig. 2).water boils (fig. 6a). The pilot light will go out.
- The minimum necessary length between the- You can switch the kettle off manually at any
base unit and the wall socket should be lefttime (fig. 6b).
free.After switching off a click may be heard. This is
normal and should be no cause for concern.
How to use the kettleSwitching on again ?
- You can switch the kettle on again after a few
Fillingseconds.
- The kettle must not be filled when placed on the
base unit. Take the kettle from the base unit.
- Fill the kettle through the spout (fig. 3a), or ...Cleaning
- ... open the lid (fig. 3b, 3c) and fill through the
lid aperture (fig. 3d). Disconnect the base unit from the mains before
Do not forget to close the lid after filling (fig. 3e).cleaning.
4 |
ACEC
PHILIPS
