TIMER
SETTING THE CLOCKSETTING THE SLEEP TIMER
When the AC cord is connected for the first time, the clock on
the display flashes.
The receiver can be automatically turned off at a specified time.
Set the time as follows while the power is off.
Press the SLEEP button while pressing the SHIFT button
1 Press the ENTER button.on the remote control.
The display becomes a little brighter.
The unit will be turned off after about 60 minutes.
2 Within 4 seconds, turn the MULTI JOG to
designate the hour and the minute.To specify the time until the power is turned off
Within 4 seconds after the above, press the TUNING DOWN or
The time advances by turning it to the right, and decreasesUP button repeatedly while pressing the SHIFT button.
by turning it to the left.You can change the time between 5 and 240 minutes in 5-minute
The N or M button on the main unit is also available. Press
the button repeatedly. To change the time rapidly in 10-minutesteps.
steps, hold it down.
3 Press the ENTER button.
The clock starts from 00 seconds.
Specified time
NOTE
When the clock is set for the first time after purchase
Everything on the display will clear.
This is because the power economizing mode of the unit isTo check the time remaining until the power is turned off
activated, and is not a malfunction.Press the SLEEP button once while pressing the SHIFT button.
The power economizing mode can be canceled. See page 7 fThe remaining time is displaoryed for four seconds.
details.
To cancel the sleep timer
To correct the current timePress the SLEEP button twice while pressing the SHIFT button
Press the POWER button to turn the unit off. Carry out steps 1so that OSLEEPoFF� appears on the display.
to 3 above.
To display the current time
Press the CLOCK button while pressing the SHIFT button on
the remote control. The clock is displayed for 4 seconds.
To switch to the 24-hour standard
Display the current time, and press the DIGITAL/ANALOG/BAND
button on the unit within 4 seconds.
Repeat the same procedure to restore the 12-hour standard.
In the 12-hour standard, OAM 12:00� indicates midnight and OPM
12:00� indicates noon.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase need to be reset.
19 ENGLISH |
ACEC
AIWA
