GZ and IH Model Series
AB
C
D
A.Light switch
B.Fan switch
C.Indicator light
D.Speed switch
Operating the FanOperating the Light
1. Slide the shelf forward.1. Open the shelf about 1" (2.5 cm).
2. Move the fan switch to 1.2. Move the light switch to the 1 position.
3. Move the speed switch to the desired setting.The light will be on each time the shelf is opened. The light
The speed may be increased, decreased, or turned off at can be used for a night light by opening the glass shelf about
anytime during the vent hood operation. The indicator light 1" (2.5 cm).
should be on when the fan is running.3. Move the light switch to the 0 position.
4. Move the fan switch to 0 or close the glass shelf.Another option for turning the vent hood light off is to close
The fan will shut off when the shelf is about 2" (5.1 cm) from the shelf.
the closed position. When the shelf is opened, the fan will
operate at the last settings.
RANGE HOOD CARE
KWVU Model Series
CleaningA
Exterior surfaces:
Clean the vent hood with a mild detergent and soft cloth.
Do not use abrasive cleansers or steel-wool pads
Metal Filters:A. Screws
For the best results, clean the filters often. Pull the tabs
downward to remove flilters. Place filters in dishwasher or hot, GZ and IH Model Series
soapy water to clean.
A
Replacing the Bulb
1. Use a 15-watt fluorescent bulb with 30" (76.2 cm) unit and
18-watt bulb with 36" (91.4 cm) unit.
2. Remove the screws above the light cover and set them aside.
3. Pull the light cover forward slightly and then downward to A. Screws
remove the cover.
4. Replace the light bulb.
5. Lift cover back into position.
6. Replace the screws.
13 |
ACEC
WHIRLPOOL
