GB
ENERGY AND WATER CONSUMPTION DATA?Rinse Hold? button
ProgrammeTemperature LoadWater Energy Programme The laundry remains in the last rinse water, without progressing to the spin cycle to
time avoid creasing and prevent colours from changing.
This option is especially recommended ?Synthetfor the ics? or ?Delicat? pre ogrammes.
(°C)(kg)(l)(kWh)(min) This option is perfectly suitable if you wish to postpone the spin or you don't wish to
Cotton905,0721,80115spin the clothes.
Cotton605,0721,15115Note: the programme selector stops on .
Coloured602,0660,80100Terminate the?Ri nse Hold? option
Press th?e Rinse Hold? button again; the programme will terminate automatically with
Coloured402,0660,40100
the spin cycle corresponding to the previously selected wash programme.Quick Wash + 1/2 Load402,5540,5085
If you do not wish to spin the clothes, switch off the appliance by pressing the On/Off
Synthetics + 1/2 Load301,0540,3070button? ?. The pilot light goes out. Turn the programme?Drain sel? posector titioon the
Delicate401,5700,6555and switch on the appliance.
PROGRAMME START
Wool401,0700,5545
Programmes with prewash last about 15 minutes more than programmes without prewash. Water andOpen ene thrgy e water inlet tap and press the O??n/. ThOff be upilottton lamp lights up.
consumption values were measured in standard conditions in compliance with the Standard IEC 60 456. Individual DOOR LOCK
consumption may vary in comparison with the values specified in the table, because of differences in supply water
pressure and temperature, the load and the type of wash.During the running programme, the door cannot be opened.
ADDING DETERGENT AND ADDITIVESThe door locks automatically in all programmes.
Pour the detergent and additives into the respective If the programme is stopped or if an electrical power failure occurs, the door unlocks
compartments as follows:automatically after about 1 minute.
Programme with pre and main washPROGRAMME END
Main wash programme without prewash The programme selector kno? ? is b at ?STOP ?.
Fabric softeners and starch1. Press the On/Off butto? ?. The pilot lighn t goes out.
Bleach2. Cancel the options by pressing the appropriate buttons.
Stain removers3. Turn the water supply tap off.
4. Wait for the door to unlock (about 1 minute).
Anti-scale agents (water hardness 4)
5. Open the door and the drum flaps and unload the machine.
Important Note:
Do not fill beyond ?MAXthe ? level mark.SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER
For programme with prewash: do not use liquid detergent.PROGRAMME START
For programmes without prewash from co°C, it is recommenld to 40ded to use a liqu1. Press thid e On/Off butto? ? to swn itch off the appliance.
detergent to avoid whitish residues on the coloured laundry.The pilot light goes out.
CLOSE THE DOOR AND SELECT THE PROGRAMME2. Select the new programme, temperature and options.
3. Press the On/Off butto? ? to switch n on the appliance.
1. Turn the programme selector kn ob clockwise to the desired programme.
The pilot light lights.
2. Turn the temperature knob to the required temperature.
TO STOP, RESET A PROGRAMME BEFORE THE END
PRESS ANY DESIRED OPTION BUTTON(S)1. Press the On/Off butto? ? to swn itch off the appliance.
?Half Load? button The pilot light goes out.
Reduces the water consumption in?Cotton the ? and ?Synthetics? programmes 2. Set the programme selector ? ? on ?Drain?.
especially during the rinse.3. Press the On/Off butto? ? to stan rt t?Drainhe ? programme.
Especially suitable for lightly soiled or small loads (reduce the quantityOnly ope of detergen the dont).or when the programme selec? ? ist ator ?STOP ? and
Not suitable for high temperature programmes.the door is unlocked (after approximately 1 minute).
5019 100 01006 |