GB
CONSUMPTION DATAPROGRAMME START
1. Plug in the appliance.
2. Turn on the water supply tap.ProgrammeWaterEnergyProgramme
duration
3. Turn the ?ON/OFF ?/?Rinse Hold? knob to the position
(l)(kWh)(min.)
if you want to choos?Rinse Hoe ld? (the programme will stop after the final rinse,
without spinning and draining, and the laundry will remain in the water).Cotton 95° C1802,00120
?ON ? if you want to have a complete washing cycle ?Rins(withoue Hold? funct the tion).
with pre-wash
DOOR LOCK
The door locks automatically after the programme start until the end of the programme.Cotton 95° C2701,80110
Cotton 60° C3701,2090
PROGRAMME END
Synthetic 60° C4600,9085The programme is completed when:
The programme selector stops in the position ?I? (?Rinse Hold? NOT selected).Cotton short 4° C05650,7075
Synthetic 40° C600,60751. Switch OFF the machine by adjustin?ON/OFFg the?/? Rinse Hold? knob to the position
?OFF ?.
Delicate 40° C6800,6070
2. Cancel the special options by pressing the appropriate buttons.
3. Turn the water supply tap(s) off.Wool 40° C7800,6065
4. Wait for the door to unlock (about 2 minutes).
5. Open the door and unload the machine.
SELECTING THE PROGRAMMENote: Do not fully close the door but leave it ajar to allow the drum to dry out.
Turn the programme selector knob clockwise to the programme with the desired
temperature. The programme selector stops in the ?Rinse Hol?d position (?Rinse
Hold? selected on the?ON/OFF ? /?Rinse Hold? knob).
PRESS THE DESIRED SPECIAL OPTION BUTTONIn this case you have 2 possibilities before removing your laundry:
?Lightly soiled / Half load? button if you choose to remove the laundry without spin, position the programme selector
Reduces water consumption, above all during the rinse.to the draining programme?E?. The ma chine will drain the water without spinning
Especially suitable for lightly soiled or small loads (reduce the detergent quand the progantity).ramme selector knob will come to rest in the s?I?.top position
?Cold wash? button if you want the programme to terminate with spin and drain, turn the ON/OFF/Rinse
Hold knob to the pos?ONition ?. The machine will automatically complete the
The water is used at the water supply temperature.programme with rinse and spin and the programme selector knob will come to rest
in the STOP position ?I?.
Note: We suggest you do not keep your laundry in the water for a long time after
completion of the wash.
In each of the above cases, terminate the programme by following steps 1-5 above.
5019 100 00026 |
ACEC
