3gb05401.fm Page 2 Thursday, December 4, 2003 2:45 PM
to drain only.
CONSUMPTION DATADOOR LOCK
Note: The programme stops to ?Rinse Hold? at the
time the ?Rinse Hold? light in the programme flow The door can be opened when the ?Door Open?
Temperature SelectorLoadWaterEnergyApprox. Programme
indication is on.indication is on.
ProgrammeDuration
(°C)(kg)(l)(kWh)(hours : minutes)*Terminate the ?Rinse Hold? option:PROGRAMME END
? Press the ?Rinse Hold? button again; the
Cotton906.054**1.902:00programme will terminate automatically with the
? The remaining time is on ?0:00? and all the
Cotton606.0491.142:20final spin cycle for the present wash programme.
lights of the programme sequence indication
Cotton405.0440.602:05? If you do not wish to spin the clothes, turn the are off.
programme selector knob to the ?Drain?
Synthetics602.5550.801:30programme and press the ?Start/Pause? button
1. Turn the programme selector to the ??
Synthetics402.5550.601:20again when flashing.position.
?Spin Speed Reduction? button
Daily403.0440.451:002. Turn the water supply tap off.
? Every programme has an automatic predefined 3. Open the door and unload the machine.
Rapid Plus303.0370.400:30maximum spin speed.
4. Close the tap and leave the door ajar to allow
Delicates401.5600.600:45? Press the button to set another spin speed.
? If the spin speed ?0? is selected, the final the drum to dry out.
Wool301.0600.300:40
spinning is cancelled but intermediate spin
Handwash301.0450.300:40peaks remain during rinse. The water is drained CHANGE THE PROGRAMME, TEMPERATURE,
OPTIONS AFTER PROGRAMME START
out only.
Prewash might increase programme duration. Consumption values were measured in normalized conditions in compliance
with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the 1. Press the ?Start/Pause? button to pause the
START DELAY
water supply pressure and temperature, the load and the type of wash.programme. The light flashes.
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the The ?Start Delay? allows to run the machine at the 2. Select the new programme (with temperature),
household conditions applicable at that time.
consumer?s convenience, for example at night any options and another spin speed if you
**To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the
water out.when electricity is cheaper.want.
? Select programme, temperature and options.3. Press the ?Start/Pause? button again. The
ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE ?Easy Ironing? button? Press the ?Start Delay? button to select the new programme continues at the same position
PROGRAMME? Can be used together with Cotton, Synthetics and delay time by 1 to 23 hours;where the previous programme was
?Press the ?Start/Pause? button.
Daily programmes to make ironing easier.interrupted. Do not add detergent for this
Add the detergents as described in the programme ? Increases the water quantity and the clothes are ? The time delay indication disappears when the programme.
table or in the chapter ?Detergents and Additives? in programme starts and it is replaced by the
spun very soft.
the booklet.remaining time.
?Eco? buttonCANCEL A PROGRAMME BEFORE THE END
? The duration of the wash is extended and the ? The number of hours preselected can later be
1. Turn the programme selector knob to the reduced pressing again the ?Start Delay?
temperature reduced to save up to 40% of energy 1. Press the ?Start/Pause? button to pause the
desired programme.button.
but maintaining good washing results.programme. The light flashes.
2. The remaining time display shows the duration of To cancel the ?Start Delay?.
the chosen programme (in hours and minutes) ?Prewash? button? Turn the programme selector to the ? ? 2. Set the programme selector to ?Drain?. The
? Only for heavily soiled loads (for example sand, spin indicators show ?0? and the remaining
and the pilot lamp of the ?Start/Pause? button position.
granular dirt) sensible. The cycle time increases time shows ?0:02?.
is flashing.approximately 15 min.? Reselect the desired programme and options 3. Press the ?Start/Pause? button to start the
and press the ?Start/Pause? button.
3. The programme sequence and the predefined ?Intensive Rinse? buttondrain programme.
spin speed indication corresponding to the
? More water and a longer time in rinse cycle is PROGRAMME START
selected programme lights up.added.
The recommended temperature (see the indicator) ? This option is particularly suitable for areas with Open the tap and press the ?Start/Pause? button.
can be altered by pressing ?+? or ?-? button.very soft water, washing baby linen and helps The pilot lamp of the ?Start/Pause? button lights
people with allergies.up.
SELECT ANY DESIRED OPTION?Rinse Hold? button
The indicator lamps show the sequence reached in
Selecting any option the indication lights up.? The laundry remains in the last rinse water without the programme. After starting the programme, the
progressing to the final spin cycle to avoid creasing
When the combination of programme, additional sequence indication runs from left to right through
and prevent colours from changing.
options and temperature is not possible, the ? This option is particularly recommended for the Wash, Rinse, Spin.
indication lights switch off automatically. programme ?Synthetics?, ?Daily? and ?Delicates?.
When the sequence of the programme is finished
Unsuitable combinations of options are ? This function is particularly useful if you want to the corresponding lamp goes out.
deselected automatically.postpone spinning to a later time, or if you want
Whirlpool is a registered trademark of Whirlpool USA
5019 301 05401/A
Black process 45.0° 100.0 LPI |
ACEC
