Basic Operations
(CDM-9807RB/CDM-9805R)(CDM-9803RM/CDM-9803R/CDE-9802RB/CDE-9801R)
SOURCE/SOURCE/
POWERMODE / LOUD (Rotary encoder)POWER4MODE / LOUD
MUTE3MUTE
Detaching the Front Panel" Controllable With Remote Control
(CDM-9807RB/CDM-9805R/CDM-9803RM/
1Press and hold the SOURCE/POWER button for
at least 3 seconds to turn off the power.CDM-9803R only)
This unit can be controlled with an optional
2Press the (Release) button at lower left cornerAlpine remote control. For details, consult your
until the front panel pops out.Alpine dealer.
Point the optional remote control transmitter at
3Grasp the left side of the front panel and pull it out.
the remote control sensor.
Remote control sensor
NOTES
" The front panel may become hot in normal usage
(especially the connector terminals), this is not a
malfunction.
" To protect the front panel, place it in the supplied
carrying case." Connectable to Remote Control Interface Box
(CDM-9807RB/CDM-9805R/CDM-9803RM/
Attaching the Front PanelCDM-9803R only)
You can operate this unit from the vehicle's
1First, insert the right side of the front panel intocontrol unit when an Alpine Remote Control
the main unit. Align the groove on the front panelInterface Box (optional) is connected. For
with the projection on the main unit.details, contact your Alpine dealer.
2Push the left side of the front panel until it locks
firmly into the main unit.
Initial System Start-Up
1Immediately after installing or applying power to2
11the unit, it should be initialized. To do this, first,
remove the detachable front panel. Behind the
front panel, to the right of the connector, there is
NOTEa small hole. Using a pencil or other pointed
Before attaching the front panel, make sure that there isobject, press the Reset switch mounted behind
no dirt or dust on the connector terminals and nothis hole to complete the initialization procedure.
foreign object between the front panel and the main unit.
1
Reset switch
4-EN |