CHAPTER 7 PICK-UP/FEEDING SYSTEM
3. Registration ClutchI. Vertical Path Assembly
1) Remove the four screws, and detach the
rear cover; then, remove the three screws,Remove the vertical path assembly.
and detach the flywheel.1) Remove the following:
2) Remove the registration clutch [1],? Inside cover
remove the clip ring [2], and disconnect? Pick-up unit
the connector [3].
When mounting the registration clutch,? Pick-up drive unit
cheek to make sure that the grip ring has been2) Remove the two rolls, and disconnect the
mounted correctly.connector; then, detach the multifeeder
assembly.
3) Remove the two screws, and detach the[3]
two positioning bosses [1] at the rear of
the copier.
[1]
[2]
[1]
Figure 7-254Figure 7-256
4. Multifeeder Clutch
1) Remove the four screws, and detach the4) Remove the varistor [2], positioning boss
rear cover; then, remove the two screws[3], and bushing plate [4] (3 screws).
[2], and disconnect the connector [3].
[2]
[1][2]
[3]
[4]
Figure 7-257
[2][3]
Figure 7-255
7-68COPYRIGHT ? 1999 CANON INC. CANON 405/335 REV.0 JAN. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON) |
ACEC
