CHAPTER 6 IMAGE FORMATION SYSTEM
13) Remove the four screws [16], and detach
the developing drive assembly [17].[16][17][18][16]
Take care not to hit the
gear [18] on the drum
shaft.
[15]
Figure 6-688
[20][19]
14) Disconnect the three connectors [19]
found on the top of the multifeeder
assembly.
15) Pull off the three pins [20] at the top, and
shift the partition sheet [21] in the
direction of the arrow.
16) Remove the transfer assembly frame from
the copier.
[21][19]
Figure 6-689
17) Remove the two screws [22], and remove[22][21][26][27]
the toner receptacle [23].
18) Remove the screw [24], and detach the
face cover [25].
19) Remove the two screws [26], detach the
two positioning pins [27].
[27] [26] [24] [23]
Figure 6-690
6-86COPYRIGHT ? 2002 CANON INC. CANON CLC1100/1130/1150/1160/1180 REV.2 FEB. 2002 PRINTED IN JAPAN (IMPRIME AU JAPON) |
ACEC
