5. Load the tape cartridge into the KL-400, making sure that the tape
Head
and ink ribbon pass between the head and roller.
Roller
6. Close the tape cartridge compartment cover.
7. Switch on KL-400 power and press FUNC and then FEED two or
three times to make sure that the tape comes out without any
problem.
Y If the tape does not come out normally, switch off power and start
again from step 1 above.
To specify the tape width
Important!
Y When using 6mm tape, certain character sizes and layouts can cause characters to run off the top
or bottom of the tape.
Y Be sure to specify 6mm tape whenever you are using it.
Y In addition to the following tape size specification procedure, you can also specify 6mm tape by
holding down the 6 key while pressing ON to switch power on. To specify another tape size (other
than 6mm ) you must use the following procedure.
1. Switch power on.
2. Press SET UP to display the setup menu.
INPUT
DENSITY
SOUND
WIDTHv
Yes SET No ESCv
3. Use s and t to highlight WIDTH, and then press SET.
WIDTH
6mm
OTHER
v
Yes SET No ESCv
4. Use s and t to select 6mm (to specify 6mm wide tape) or OTHER (to specify another width), and
then press SET.
4-4. Display Contrast
Rotate the dial on the side of the KL-400 to adjust display contrast.
N 12 N |
ACEC
