7-3. Operation Check
1 Perform 3-2. Set Up of this manual.
2 Perform the procedure described to the page 35 or 36.
3 Tap Start, Settings, and Taskbar.
Power
MIC
4 Select Auto hide, and then tap OK .
5 Press Tasks button while holding down Power button.
Refer to the right figure.
PowerTasks
6 After performing this operation, the following Main Menu appears in the LCD display.
** Main Menu **
1 DISPLAY
2 TOUCH PANEL
3 MEMORY
4 SERIAL
5 POWER CONTROL
6 AUDIO
7 Others
8 AUTO MODE
9 GRAY SCALE
CPROG Rev. xxx for Angel
(APO OFF)
< In case of using Compact Flash memory card >
After this display appears, you may pull out its Compact Flash memory card.
Even if there are no Compact Flash memory card, this OPERATION CHECK can be performed because
the diagnostic program was already saved to RAM of E-10.
ITEMOPERATIONDISPLAYNOTE
DisplayTap 1 DISPLAY.Checker
N 37 N |