OPERATION
Transmitting MIDI Messages
To transmit MIDI messages, set the Mode Switch to the MIDI OUT position.
Operation 1
The note number is transmitted when the corresponding key is pressed.
Use the Octave Shift Switch, and select the position appropriate to the octave range you want. GZ-5 can send
note numbers 17 to 108 but it has 32 keys only.
Velocity is also transmitted when a key is pressed. GZ-5 sends the velocity in accordance with the selected
position of the velocity switch.
Data of pitch bend and modulation is transmitted when the corresponding switch is operated.
The values of the velocity, the pitch bend and the modulation switches are automatically set up to the initial
value when turning on the power.
See the appendix for information about the initial value.
See the following table for instruction how to change the value.
MIDI MessageOperation switchSettingOpeartion for setting
Note No.Keyboard
Octave shift switchOctave range See the figure below
VelocityKeyboard
Velocity switchVelocity value CONTROL + VELOCITY, XXX, ENTER
Pitch BendPitch bend switchBend sense BEND SENS, XXX, ENTER
Bend curve BEND CURVE, X, ENTER
ModulationModulation switchModulation depth MOD.DEPTH, XXX, ENTER
Example of operation : CONTROL + VELOCITY, XXX, ENTER
Press CONTROL button and VELOCITY button at the same time.
Use the 10-key pads, enter a 3-digit number.
Press ENTER button.
Position of the octave switch and octave range
C1C2C3C4C5C6
C1C4=60
C2
C3
C4
C5
C6
N 3 N |
ACEC
