ADJUSTMENTS
POWERSETAbout pilot lamp indication;
EASYEASYMENUBACKLight in green ...................... Stand by
�+Flash in green ..................... Data transferring
Light in orange .................... Printing
Light in red .......................... Data transmission error
DP-300 button arrangementFlash in red ......................... Other errors
1. Current check
While inputting DC20.5 [V], make sure that the current consumption does not exceed the following values
abnormally.
Power off ........................DC 52 [mA] typ., DC 60 [mA] max.
While printing.................. DC 1.45[A] typ., DC 1.6 [A] max.
2. Unit check
DP-300 contains self check program. Before check, connect DP-300 and a digital camera QV-100, QV-200,
or QV-300 with cable SB-62. Use above mentioned cameras only.
SequenceOperationQV camera display or DP-300 print out
Turn the QV digital camera on.
1
2While holding down OBACK� and OEASY�KX701 TEST MODE1KX701 TEST MODE1
buttons, press OPOWER�.
VERSIONVERSION021Indicates the ROM version
Hold down those buttons for more than
ROMCHEKROMCHEKOKShows "NG" if the ROM is faulty
one second.
HEAD RANKHEAD RANK 4Normally within 0 to 9
Power lamp lights in green � red �
TEMP NOW26Head temperatureHead temperature
orange, then green.Should be within 23 ?5!C
PUSH ANY KEY
3Push any button (except POWER) to
TAPJAM
proceed to sensor check.
PAPERShown when paper is in
3 1RIBBONShown when tape cartridge
is in
2HOME should be indicated
CUT
4 EASY MENU BACK
5
6 ( � ) ( + ) SET
4Press each button of DP-300 and makeTAPJAM
sure that mark appears underneathPAPER
3 1RIBBON
the pressed buttonOs name.
2HOME
CUT
4 EASY MENU BACK
5 appears when
6 ( � ) ( + ) SETcorresponding button
is pressed.
5Turn DP-300 off.
N 2 N |
ACEC
