EN/LZB 119 2506 R1AService of the Telephone
Replacing the Vibrator Wires
The vibrator wires are part of the vibrator motor assembly. If the wires become
damaged, the entire motor assembly must be replaced.
Replacing the Keypad
Perform the following procedure to remove the keypad:
1. Disassemble the phone. See Disassembly, steps 1 through 7 (AF738) or steps
1 through 11 (AF778).
2. To remove the keypad, simply pull it off the PCB.
3. Re-position the keypad into the front cover, not the PCB. This will ensure
proper alignment when putting the main assembly back together.
Replacing the System Connector
Perform the following procedure to remove the system connector. See Figure 2-4.
1. Disassemble the phone. See Disassembly, steps 1 through 7 (AF738) or steps
1 through 11 (AF778).
2. Gently pull the system connector back and forth until it comes off the PCB.
Note the way it was positioned.
3. Carefully hold the PCB by the edges and re-install system connector by
pushing onto the PCB.
CAUTION
Be careful not to reinstall the system connector upside down.
5-20 |