Thermistor Removal
Figure 1-47Thermistor Connector
1Remove the Wire Harness Cover as shown in Figure 6-47.
2Remove the (2) screws from the thermoswitch connector (see
Figure 6-47, callout 1).
3Release the thermoswitch latch from the paper sensor flag
side of the Fuser Assembly (behind the side cover, see Figure
6-47, callout 2).
4Slide the thermoswitch to the gear side of the fuser and
release it from the fuser frame (callout 3).
NoteWhen installing the thermoswitch, make sure the
sensing surface contacts the fusing roller
uniformly. If it does not, straighten the leaf
spring.
(continued on next page)
6-56 Removal and Replacement |
ACEC
