SETUP
Manual Convergence Adjustment Mode
NOTES: 1. Please turn ON your television for at least 20 minutes before using this feature.
2. Auto Adjustment Mode is recommended. If convergence is still not acceptable, use the Manual Adjustment Mode.
DO NOT press MAGIC FOCUS or use Auto Adjustment Mode after using Manual Adjustment Mode.
Using the Remote Control, select SETUP-MAGIC FOCUS TUNE UP-MANUAL ADJUSTMENT MODE-START to access convergence
crosshatch pattern. The adjustment point is indicated by the Adjustment Point Cursor.
To Move Adjustment Point
To move the adjustment point cursor using the THUMBSTICK, the Adjustment Cursor must be WHITE. Another way to move the
Adjustment Point Cursor is to press the following buttons: [2] up, [4] left, [5] down, [6] right. If you use the number buttons while the
adjustment point is WHITE, it will change to RED.
To Change the Color of Adjustment Point
Press the SELECT button repeatedly (WHITE-RED-BLUE-WHITE...). Green color is fixed and cannot be adjusted.
To Adjust the Convergence
Move the Adjustment Cursor to the point to be adjusted. Use the THUMB STICK to match the RED and BLUE colors to GREEN
(reference color). Properly aligned, all three colors should appear white.
VideoSetup
AspectMagic Focus Tune Up
AudioMenu Preference
Chan. ManagerTHUMBTHUMBSet The Clock
STICKSTICKSet The Inputs
Locks
Set The Color System
SELECT
MENUSetupSet Virtual HD
MoveSELSel
Set Black Side Panel
Set Event Timer
Set Closed Caption
About Your TV
MoveSEL Select
THUMB
STICK
SELECTAdjustment Point
Cursor
Setup
Magic Focus Tune Up
Aligns the Red, Green, and Blue
colors to correct for Magnetic
Influences.THUMBTHUMB
STICKSTICK
Adjustment Mode
AutoSELECT
Manual
If you want to adjust nowStart
MoveSEL Return
If convergence is acceptable after Manual Convergence adjustment, press EXIT button to access menu mode.
117 Manual Adjust
Please Enter Number.
0.Cancel and go to Normal Mode.
1.Done and go to Normal Mode.
EXIT2.Back to Adjust Mode
3.Factory Reset and
Back to Adjust Mode.
0-3.Select
Press the [0] button on the remote control to CANCEL adjusted data and return to main picture.
Press the [1] button on the remote control to SAVE adjusted data and return to main picture.
Press the [2] button on the remote control to return to the manual convergence adjustment mode (crosshatch pattern).
Press the [3] button on the remote control to recall the factory pre-set convergence data.
57 |